Hi :)

I have a slight problem with the suction to waste option on my multi port.

(Its very similar to a Hayward filter)

The PSI reading when switch to waste is...

I'm trying to narrow down the cause of a sudden rise in pressure (even after a good backflush). I suspect contamination on the filter bed. I found what looks like gooey...

Hi, experieincing something new here. The discharge pressure is up to 22 from a normal 15 psi. I flushed the filter for two minutes this morning, no change. The filter...

We are having problems with the DE settling on the bottom of our system. Which makes the pressure stay up on the pump. Any help would be greatly appreicated. I'm...

A few weeks ago my aunt and I tryed to clean the DE grids, and noticed some tears. We went to Lelies, bought new grids, and reassembled the filter.
We made certain that...

When one is used in the pump & filter, how should I store my spare? Do I have to add chemical solution?

I heard after a few months you have to add a chemical...

Above ground, self priming 5000 gallon plunge pool with Haward Sand Filter, Ecomatic Salt Water Clorinator and newbie pool person.

After I backwash, the psi on the...

Any help would be appreciated. My PH is correct in my above ground pool but no matter how much chlorine i put in the pool wnen I test the water it gives me a negative...

I am new here so please bear with me if these questions were already asked somewhere (looked but couldn't find that they had been).

1. do I need to run my sand filter...

I have a problem with my pool. I clean my pool with the vacum for a few minutes and it looks like it's working but then all of a sudden the dirty water comes back throgh...

I have a 18x33 above ground

currently have a hayward cartridge and it looks like I may need a new unit

anyone have any rave reviews?

How often are you supposed to change the sand in filter?

How will you know if it needs changing?

sharoninhattiesburg

I just opened my pool two days ago and the de filter is already losing pressure. The guage read less than 10 and within 24 hours it went to above 20 and hardly any water...

we vacumed the pool and now the pump will not work. we backwashed and the pressuer of the water is very low. what can i do???

OK so I have determined that I have a cartridge filter and now want to figure out a few things I am going to insert a pitcure to assist in my questions, any help is...

What products are available for repairing a small hole?

I am new at operating a swimming pool. Last year I built a 52' x 12' x 4' in-ground pool with vinyl liner. The capacity is 18K gal. The system has 1 1/2 HP in-ground...

Pressure gauge is at about 20 psi when off; when filtering it maxes out (over 30 psi). The filter is about 6 years old. Replaced pump last year; that is working well....

Im looking after a in ground pool it has no vac outlet so i vac from skimmer the problem is if i close bottom drain pressure go straight to red but if i crack it open a...

Hello-

I have an inground vinyl lined pool around 10000 gallons. I have a Mytilust Titron FMY 100 Cartridge Filter. When I go to vacuum the dirt comes right back out...