i am still battling the problem of not being able to increase the ph level in my pool. i finally attained the level of ta i needed - 130 ppm. a 25000 in ground vinyl...

We have a 6000 gallon vinyl pool, and have been enjoying it for the past three months, however for the past week we have been unable to rid our pool of the whitish...

We have a salt water pool, which is around 5 months old. This week we noticed that the 3M plaster is like very rough sand paper. We were wondering if it was caused by...

I recently installed an inground pool, and filled it with well water and my total alkalinity is pretty high. I've already bought muriatic acid and expect to follow the...

I've put in two bags of salt in the last week, chlorine level very low and intellichor says i need more salt. ph is ok a little high TA 240

I've been doing a lot of reading and there seems to be a ton conflicting info on "proper" pH and TA levels.

I hear that 80-120 are good numbers for TA, but...

We have a spa/pool(spool), fiberglass, in-ground, 2500 gallon. Our Ph level is way too low(yellow) and we can not even get a Alk reading. Our water is clear yet sour...

my alkalinity never seems quite right on my 3 way tester strips but my pool seems fine and my chlorine and pH is the right colour. Does this matter? any comments would...

Hi,

I have a fiberglass over gunite pool with 24000 gallons. I have been told that the TA should be between 80 to 100 ppm and the pH between 7.4 to 7.6.

I have been...

I have the drops-type water tester. Tonight it told me pH was ideal but alkalinity was at 150PPM. According to the instructions it should be 100. I read somewhere that...

we normally don't use to much chemicals in our pool. we do use shock, swim & shock, and chlorine tablets. Our pool got a greenish tint to it, but it wasn't algae. we...

I have High total alkalinity and low PH. Total alkalinty is 218, PH is 6.8, and I'm constantly adding PH UP. Can't seem to get it under control. I do have BioGuard®...

after refilling the pool with mains water . after refurbishment of pool suface. i have a high total alkalinity of 250+ but my ph is good at 7.4.

the pool is 20,000...

My TA is 130 and PH is 7.4. I like my TA at 110. I have sodium bicarbonate to raise it but nothing to lower it. I may have some myratic acid but i will have to go look....

I posted the thread before about my pH not increasing. Well, I finally got it up, and it turns out my CYA level is insane (probably 200+). So the pool is draining right...

I have a haze on the surface of my pool water ,cloudy water, and skin feels sticky after swimming. MY TA is high 180or higher, as is the ph 8.1. I ve shocked my pool and...

Where can I purchase Muriatic Acid?

Im in East Providence, RI

Thanks

im currently new to pool matienence and most of my pools are now high to really high in alkalinity / ph ta of 120 to 280. most of my pools have a ph of 7.2-8.0. i was...

I have an Aqua Leisure 18' x 4.5' (deep)- 6,000 gallon easy set vinyl pool - using it for my 2nd season and still can't figure the right balance of chemicals out. This...

I've read many of the posts on this forum re: PH and TA. Most of them refer to good PH levels, but High TA. My problem is that I always have high PH readings and a TA of...