My ic20 low salt light has no reading at all i know they can go off during
cycles but its staying off.all other lights are green i did add some salt
my salt strip reads...

Where or how can I test my AutoClear ACL=1?

None of my local pool stores can? It is 6 years old.
Every year I soak cell per instructions and never have had any...

I have a Zodiac Clearwater LM2-24 salt water chlorinator, about 6 years old. The system is failing to produce chlorine, and showing only 2 (of 6) lights in the output...

the pool company installed a ozone generator when they put my pool in. the line from the generator goes to the vacuum side {at the pump} i've been saying to them that...

Hi, everyone -- My AutoClear Plus salt water generator seems to have died after only four years of use, so I'm shopping for a new system. Two local pool companies offer...

The power lite on the chlorinator does not come on. There is power to the power box and fuse is good. Why would the power lite on the chlorinator not come on?

Hoping someone can help me with my 8110 SWG
After performing wonderfully for a couple years, one day i noticed that it wasn't completing its cycle
it turned on, said it...

Hi all,

I had a chlorine deficiency in my salt-system pool which was fixed by addition of stabilizer. However, the chlorine jumped really fast once the stabilizer was...

Hi All I am looking for advice. I have been struggling with my SWG since I installed it about two months ago. I cannot convince myself it is doing anything since I am...

Yea I done read other post but no glory. Salt at 3200, also checked two other ways and got same reading. Clorine at zero.I also tried super clor. Used another test and...

Hi all,

What are the typical electricity needs of a SWCG? My HOA has considered buying one for our community pool vs the trichlor feeder we have now, but we have...

I have a 4 year old AutoClear Plus salt system. The salt cell was replaced less than 2 weeks ago. Now I am getting error message 94. What does this mean?

I know this problem has been discussed about the 8110 SWG, but I have the combo unit model CS 15110.
The problem is the same - the system starts and runs for about 1-2...

Do I need to leave my saltwater system on when adding dry acid to my vinyl lined above-ground pool?

I have an Intex 8110 salt water system that I have had for about 3 years that has some sort of power issue. It will run for around 20 minutes or so then it just shuts...

I have an AutoPilot Pool Pilot Digital Salt Generator with an SC-60 cell. I am extremely disappointed to have a failed power supply shortly after it's out of warranty....

all the bubles on the solor cover have flattened out called the dealer where i bought it and he said he never heard of that happening then he said sometimes the chlorine...

I have a Pure&Clear system, which was bought out by Polaris and is now called the Autoclear. I get the following error codes numbers when I press the...

I just installed an Intec CS8100 and the instructions say to add salt - which I have found. But my question is can I use HTH Salt Pool Care products as a substitute for...

I have a question that I couldn't find addressed here. I just had my pool replaced about 3 weeks ago. 27' X 52" above ground. It seems that an overload of drifted...