Has anyone heard of problems associated with a salt cell system being damaged or destroyed by a corona discharge Ozone generator.

Our pool installation company talked...

Hi all

I've got an issue with my Chlorinator. It has stopped produced salt, complaining that the salt level is too low.
However, I took my water to a pool shop, and...

Hi everyone,
I looking to purchase a Salt Testing Pen. So that I can check to see that I have enough added SALT in my pool water for my Salt Chlorinator to produce...

I just noticed my pool was a little cloudy so I checked my unit and only my power light is on when the pump is running. I have tried to reset everything, unplug all...

The display on my Clormatic II CM601 display indicated "no flow" so I replaced the flow sensor. When I powered up the unit with the new sensor installed I got...

Being in the health industry and knowing what adverse health issues are associated with Chlorine, I prefer to take my chances with mineral products to treat my water. I...

I have a new ic 20 pentair salt generator i have had it set on 80% still no reading
i took a test sample today none at all.my cya is at 30 they say is fine i just dont...

I've only had the Intex CS8110 SWG with Copper Ionization for one day and now it won't light up the LCD. I am not sure if it's the power supply (transformer) or it is...

Hello all,

I am new to the forum and have a general question.

I have a large in-ground pool (24x48) with a hopper bottom and a vinyl liner. My current sanitizer is...

HI! I have a model 8111 SWG. It is a pump/filter/swg unit. It has worked great for 3 years. This season I get code 90. I have disassembled cleaned /inspected EVERYTHING,...

My 8110 is causing a ground fault but runs fine on a regular outlet. Is it dangerous for me to run this unit overnight when no one is in the pool and unplug it during...

Has anyone heard of this brand name before and have any comments on the features and reliability. There is very little info on the web. The model I am looking at is the...

Anyone here care to give an opinion on the claims on this website?

This is the company who is maintaining our HOA pool and he's trying to talk our HOA board into...

When I run my swg through is cycle the chlorine is usually on the high side 3.0. Do I have to run it everyday or should I run it every other day to get the chlorine...

Hi I'm new , I have a 12x36 1,779 gallon pool. I bought a SWG with a built in 2000 gallon filter. My problem is that when I try to adjust the PH and put in baking soda...

Hello,

I had a IC20 salt generator installed with my new pool and have been struggling to get enough free chlorine produced for my 75000L pool. I used a salt generator...

Why do people say to disconnect the copper producer on the Intex Salt Water generator?

I have the Aqua Rite system and it has been working good (for the most part) over the past three years. Recently, however, is has lost communication with the Jandy...

If you are planning on throwing out your Intex Saltwater Cholrinator 8110 then perhaps I would be interested in buying the power supply (transformer).

has anyone troubleshot the "pcb" error code on the aqua-rite control panel?
i was hoping someone could direct me in my troubleshooting today. looking for...