I hve the Aqua Trol HP on a 24 Ft above ground and have been very happy with it. Recently the salt reading, both average and instant dropped from around 3200-3300 to...

I have an Aquarite about 6 years old.

I have NO display, the 4 leds (Low Salt, High Salt, No Flow, Inspect Cell) are flashing.

I tested the PCB with a VOm and have...

6 year old Aquarite stopped working this week. Cleaned the cell last week and added salt. Salt is now at 3300. The first symptom was the display read 200 when I knew I...

I noticed that the "No Flow" LED light was solid red so I called our pool guy. The water was crystal clear and when I took a reading of the water, the free...

I have put too much salt in due to a bad cell. I was wondering if I really have to drain the pool or can I just turn the cell on for a short period until the salt gets...

I've had the aquarite sytem in place for ~6 years. Had the motherboard replaced after 2 years for free and have had to replace the cell once. New problem: the system is...

I am thrilled I stumbled on this site. Tons of great information and I apologize in advance if this question has been previously answered.

I have an AquaRite system...

Hi,

I have a Goldline Chlorinator.

My pool is cloudy form the salt. What can I do to clear the water?

All my chemical level's are correct.

I used Morton's table...

We have had our salt system for approximately 4 yrs with little trouble. The usual "clean cell", "low salts" etc... But this the first time that...

I have a intex metal framed pool, 16x48, and have a intex salt water system. Do I still need to put cyanuric acid in the pool when i set it up?

We are changing addresses and pools. Going from a chlorine pool to a pool that has a Chlorine generator. I did all the pool maintenance and chemistry.

The chlorine...

I'm going to be installing a Sense & Dispense system that has a SWG, a cartridge filter and Goldline ProLogic controller. My question is regarding the plumbing of...

I have a outdoor, 21,000 gal plaster pool, screened cage, no pool cover, solar heat, SWG, cartridge filter, sense & dispense system, Stenner 5 gpd variable speed...

I have a salt water chlorinator and the "add salt" stays on continuously.

1. I have added salt and tests indicate there is plenty of salt
2. I have had the...

I'm going to be installing the sense & dispense system with a SWG. I will be using a Stenner pump/tank to inject muriatic acid. The acid will be diluted 4:1 with...

I am a new pool manager for a 50,000 gallon neighborhood pool. We are using a salt system currently and our chlorinator has just failed. So, we are currently shopping...

I recently bought this house qith an Aqua Rite system on a spa. Chlorinator didn't work (no flow) and after replacing the cell and flow switch it was ok for about two...

This is the third year I've had the pool, and the second time the Aqua Rite system just stopped making chlorine of any appreciable level. Pool chemistry is dead on. The...

I have a 17,000 gal gunite pool with a Sunshine copper,zinc,silver ionizer and a THUNDER
Corona Discharge Ozone Generator with a Thunderstorm injector system.
My...

I have a 36 x 18 x 5ft av under 30k gallons vinyl liner pool 6 yrs young with a heater 400k btu and de jandy filter and big valves...want to convert to a swg and I am...