Does anyone have experience with products like BioGuard Mineral Springs Beginnings extending the life of your heater? Or can anyone tell me how many years of heater...

can some body tell me how to lower the free chlorien level in your pool

thanks

john

how specifically do i inspect and clean cell. i've searched online for pictures of what exactly is the part i'm supposed to clean and can't find anything. what am i...

i just put a 36W UV sterilizer in my fishpond (about 2000ltrs of water i think). it was pea soup green when i installed it. i though i would see what happened but didn't...

replaced the cell 12 months ago. when you power up the unit, the read out screen will come on, the flow lamp will blink, then generate lamp will come on for just a...

Im installing an Aquarite chlorine generator and I dont know what gauge wire to use to connect the generator to the timer. Can anyone tell me?

I have an Autopilot Cubby/RC-5 in deck system. Considering switching to SC-36 In Line. Anyone tried this? Would prefer to do it myself......does not seem too difficult....

My Aqua-rite system generates for 10 seconds, then ceases to operate.

After the system is turned on, the "no flow" light flashes (which is normal) then the...

replaced cell. system comes on and generates for about 60 seconds. shows it is generating. you hear a click and then the low salt and check cell both come on and stay...

Hello all and thanks in advance for any help.

I recently egan getting audible alarms on my unit and the amber service light illuminated. I contacted chlormatic but...

I have a pool salesman suggesting I save money and get a $500 Nature 2 Mineral Pool Sanitizer rather than a $1700 Autopilot chlorine generator. This sounds suspicious to...

i have new installed a AquaRite 20 with a T5 cell.

the chlorine production is very low for the 20'000 GAL pool.

can i just replace the T5 cell with a T15 cell, or...

Here's what I'm thinking...

I don't have a problem of lugging jugs of chlorine to my house.

What if I add salt to the pool to get the correct level of salinity.

Then...

Our pool did not get properly winterized. we ran the system when it got below freezing, but there is now a crack in the cell housing. we tried to patch and were somewhat...

I just purchased a used Mineral Springs MS-10. I don't know to much about SWG's as I have never owned one but they sound great and it was cheap enough that even if the...

Thanks!

Hi,

I have two code errors 125 and 194 and can't figure out what the problem is. can anyone assist? TIA.

We have a large rehab salt water pool and although we have cleaned the chlorinator weekly, and maintain the levels twice daily we can not seem to get the levels...

My low salt light is staying on. I have cleaned the cell, but the low salt light keeps blinking. I do have enought salt in the pool.

Our previous Pure and Clear system has bit the dust. So, we are trying to decide the best system to purchase for replacement. We have an above ground pool. Which is the...