I asked awhile back about using UV lights to sanitize our communal pool.
It has now been done. Our pool is about 120,000 gallons. The water for it comes from wells that...

was like this once then just started working had to clean cells now its back to stuck on 88 not flashing and beeps when u push the up arrow nothing on down arrow

I have an Aqua Rite electronic chlorine generator-T cell 9. It has been working well for over 7 years. It worked fine all winter but suddenly isn't procuding any...

So, I purchased a home from family and a swimming pool was installed about 8 years ago. The pool is a saltwater setup and the IC40 has been replaced two times. I wanted...

Hello, I'm new here and I'm in the process of purchasing a new viking fiberglass pool.

I haven't settled on a filter system but I'm hearing a whole lot about Ozone...

Two years ago, the guy who installed this unit for me set it so that every time the pool pump went on, the chlorinator would turn on as well, at the 50% setting. That...

I put up a 16' x 48" Intex pool last weekend and my salt water system keeps going into sleep mode and the LOW SALT light keeps coming on. I have just put in the 6th...

Hello Everyone,

We've recently moved into a home that has a salt water system. It appears, however; that the system isn't actually running. From what we can see, the...

I have recently installed the above chlorinator having replaced the old unit which became defective ( and it was old).
Since then I cannot balance the water correctly....

I am struggling with my new pool build. I look online and all manufacturers say not to use salt water with steel walls because they will only last 10-15 years. I have a...

I have an AquaRite generator that reads 3300ppm. I tested the water using strips which resulted in 2800. Which is more reliable? What could be causing this?

I tried the...

In an Intex SWG w/ ozone (but probably doesn't matter), what does the titanium cell environment look like when the system is working correctly? Am I supposed to be...

I've had my unit for 5 yrs and have never replaced it.....Its always on at 97%. Just last week, the "NO FLOW" light has been on and now the unit does nothing...

Hello, I am new to pools but have reading this and other forums and learning as fast as I can. I am converting to a SWCG. Specifically I am putting in a Hayward AQR15....

my new intex saltwater system at first would take 20 to30 minutes to kick on after my pump/filter would turn on now it will not come on unless I turn the switch off then...

Hi Everyone,

In the interest of the global collective. I thought I should report my successful repair of a Zodiac Clearwater LM-2 'push-botton' control PCB (Printed...

Hi All. I am new to your forum. I am situated in sunny Cape Town. I have years of experience in maintaining both chlorine and salt pools. I recently bought a new house...