Anyway to get a hacksaw blade onto it without damaging the rest? I have had to use a hacksaw blade broken in half to make it smaller and just wrapped...

The first thing you can do is fill pool to normal level and leave it off for 24 hours and see if you loose water. If you do, let it go down and see...

Have you checked skimmer for debris?

You could have something stuck in pipe/line between skimmer & pump, you can take pump lid off, insert...

sounds like you are doing everything correct, maybe ask to talk to 3-4 customers they have done jobs for and you will know their opinions.

to start out fill pool up normal and turn everything off for 2 days.

If the water level goes down you then know its in the pool and not the...

Liner life varies widely and depends on a lot of things including how well you maintain ph, amount of direct sunlight, chlorine levels, etc. Anywhere...

This is occurring because your "spider gasket" is bad/ripped/torn on your multi-port valve. You need to replace it.

To prevent this in...

What kind of filter do you have?

You call it a "safety valve". Are you sure thats what it is? If so...then perhaps it's doing it's job and something is over pressurized...

What brand/model/size of filter?

There are now about 5 holes in the liner, each the size of a quarter or 50 cent piece. The pool, as far as I can tell, was installed correctly -- we...

It's air. Your pump is probably a little bigger than you need so when the filer is clean it creates a tremendous vacuum. You have small leaks in...