How do I fix a leak if it is around pool light - the casing was loose and I put putty around it but then realized, if bulb goes out, I need to take that off - anyway -...

Can anyone suggest the best material for repairing the floor to wall joint to stop water weeping in vaious places when pool is empty. The pool is built on a slope so...

my vacuum has pressureized water going through it but it does not move. The back end lifts up like its trying to go. I replaced bearings in wheels and back-up valve....

Has anybody tried an tested a underwater silicon to repair holes or splits in liners?

If so please name it

Help!!!

The filter was good as new yesterday. But today the filter doesn't seem to work properly, the suction is weaker than before, and the water flows very slow....

Hi when i run my polaris automatic vac i lose water in the pool.Is this possible? and can i pressure test the line somehow? my pool is inground 18x36

Just discovered a pin hole leak in the pump housing, which appears to be made of a tough black plastic material. Will my trusty JB Weld handle this, or does the pool co....

We have a Viking fiberglass kidney shaped drop-in pool. It is supposed to take 47,000 PSI. We just noticed a 'tumor' on the bottom of the pool. Approx 4'x1'x2-3"...

I had a new 24 ft. pool installed. After pool was filled and we noticed that there is a leak. The installer insists that it has to be a hole in the liner and we now have...

We just opened the pool the other day. However it doesnt' seem like the pool is filtering properly. It appears that we have little flow on the returns. The Filter is...

Pool is a Vinyl inground 3'-6' depth:

Last night I noticed the umbrella from the patio table by my pool was missing. I went over to take a look and it was nowhere to...

I had a leak in my new liner last August and repaired it with a small kit.

It leaked over the winter again. I am planning to repair the holes once more. Should I remove...

Ok - so I have a couple of problems going on.

1. Pressure is about 8-10 PSI lower than it should be.

2. Water leaking from backwash port.

3. Multiport valve...

My pool was built last August and I opened it early April. It's been solar covered for a couple weeks and I notice a 4ft long faultline along the slope in the deep end...

I have a new pump and I am getting little to no suction. I get the same thing when I just recirculate. I know I keep getting a lot of air in the filter. What could be...

I was losing about an inch of water a day. Did the bucket test and determined I have a leak. Turned everything off for a week and the water stopped leaking once it...

I was told the reason my filter doesnt build up pressure is because I have air getting in some where I lubricated the o-ring under the pump lid and it helped the flow....

My DE filter is leaking at the junction between the top and bottom. The O ring looks fine and I have lubricated it as well. I put the clasp on to join the 2 peices and...

We had someone in who was able to pressure test and find where the leak in our inground vinyl pool was. It is just below the skimmer. We opted to dig the trench...

In the deep end of my pool there is a 1/2 small wrinkle and my pool cleaner has rubbed the top of the wrinkle off causing a 1/2 hole in my liner.

How would I go about...