I have a few places in my hard piping going to my Filter and Auto Cleaner that are leaking a little. I have tried teflon tape, and teflon compound. Neither of these have...

My in-ground pool loses about 3/4" of water per day. I am not getting any air into the filtration system through the skimmer or bottom drain lines (hopefully this...

I have an inground pool and jacuzzi. In the past week the Jacuzzi drops rapidly and the pool level increases. The two share filtration systems. No signs of external...

i just came home from three days away and the poolwater is 3-4 inches below the skimmer boxes. I freaked. It is Sunday and I can't reach any pool companies and my...

I am still in the process of getting my steel walled, vinyl liner, vermiculite bottom pool built. Just before concrete arrived on Thursday, the contractor noted that the...

Why do my above ground hose fittings always drip? What am I missing.

My hose is medium-quality with that spiral slinky kind of ribbing. I'm putting it on the...

How do I fix a leak if it is around pool light - the casing was loose and I put putty around it but then realized, if bulb goes out, I need to take that off - anyway -...

Can anyone suggest the best material for repairing the floor to wall joint to stop water weeping in vaious places when pool is empty. The pool is built on a slope so...

my vacuum has pressureized water going through it but it does not move. The back end lifts up like its trying to go. I replaced bearings in wheels and back-up valve....

Has anybody tried an tested a underwater silicon to repair holes or splits in liners?

If so please name it

Help!!!

The filter was good as new yesterday. But today the filter doesn't seem to work properly, the suction is weaker than before, and the water flows very slow....

Hi when i run my polaris automatic vac i lose water in the pool.Is this possible? and can i pressure test the line somehow? my pool is inground 18x36

Just discovered a pin hole leak in the pump housing, which appears to be made of a tough black plastic material. Will my trusty JB Weld handle this, or does the pool co....

We have a Viking fiberglass kidney shaped drop-in pool. It is supposed to take 47,000 PSI. We just noticed a 'tumor' on the bottom of the pool. Approx 4'x1'x2-3"...

I had a new 24 ft. pool installed. After pool was filled and we noticed that there is a leak. The installer insists that it has to be a hole in the liner and we now have...

We just opened the pool the other day. However it doesnt' seem like the pool is filtering properly. It appears that we have little flow on the returns. The Filter is...

Pool is a Vinyl inground 3'-6' depth:

Last night I noticed the umbrella from the patio table by my pool was missing. I went over to take a look and it was nowhere to...

I had a leak in my new liner last August and repaired it with a small kit.

It leaked over the winter again. I am planning to repair the holes once more. Should I remove...

Ok - so I have a couple of problems going on.

1. Pressure is about 8-10 PSI lower than it should be.

2. Water leaking from backwash port.

3. Multiport valve...

My pool was built last August and I opened it early April. It's been solar covered for a couple weeks and I notice a 4ft long faultline along the slope in the deep end...