pool has been slowly rising(2" over 4 years) on one end. pool has never leaked and is now for the past 2 weeks started leaking. its still above the returns and...

Replaced liner in 16 x 38 inground in new home. Pool was out of service for several years (liner fell in). We are losing about an inch of water a day, noticing some soil...

Inground pool is losing water. Called a local company, they suggest checking the skimmer throat for a leak. How is this done? No cracks or leaks are visible, so do you...

I am loosing about 2" of water a day since I turned on the pool. It is gunite. I turned off the pump and it s still leaking the same. I have let the water drop...

Leaked down last fall below the return lines so I pluged the holes for the Ohio winter. To my suprize it was full to the line on the skimer this spring so I run the pump...

Our gunite pool is 12 years old. We just finished draining it for the first time and did an acid wash to clean it. However, now that we are trying to refill our pool,...

Hi, new pool owner here. I have a 40'x23' inground vinyl liner pool which was opened 2 weeks ago. Current average conditions have been low humidity (45-50%), moderate...

Hi! We just bought this house in November.. It came with a pool. The pool is about 10 years old. The liner is fairly new we were told. We've been swimming in it after...

First the pump had to be replaced, now the pool is leaking, and I can't figure out where the leak is. It doesn't seem to be the multi-valve, and I can't see any obvious...

pool loses 3/8- 1/2 " of water in 6 hours of running. Notice loss of pressure of maybee 2 points. ?

the side wall of my pool rusted and caused a hole about 6 inches from the bottom...hole is about 2 inches in diam. this is the 3rd year in a row this happened and the...

My cleaner intake line does not have enough suction to work my auto pool cleaner properly. When I partially close the skimmer to increase the pressure, the pump loses...

The liner has stretched out from under the return, exposing approx 1/4 inch of backing. The exposed area is roughly 1/3 of the diameter of the jet. The pool is 20x40...

Hello again!

I'm not getting any further with finding the source of my leak. One thing I've found that might be my problem is that the concrete surface of my pool...

I have a 20x40 inground pool. Had 2 tears repaired before winterizing, opened up 2 days ago, and pool is empty 1/2 down the slope to the deep end. Waiting for the leak...

the clear plastic top on the skimmer housing will not seal properly.I used the teflon lub when installing a new gasket yesterday but it acts like the top is warped...

I'm in Cleveland and we had a break in the cold weather and snow last week so I went to check on our in-ground pool since I noticed that the snow and ice had sunk the...

Turned my pump/filter on today and discovered a leak coming from the pressure gauge. (Sand filter for an above ground pool). Is the repair as easy as taking off the old...

Over the winter I had all the valves turned off and pool level stayed the same. Once pump was turned on I have noticed that the water level will go down slowly over a...

My new pool has just been filled and we discovered a leak coming from a jet in the "buddy" seat. The backfill has not been done yet, so we still have total...