I am replacing a vinyl liner with a grout bottom pool and fiberglass walls. There is a shotgun effect on the liner in many areas of the bottom. How should I go about...

How do you know when your fibreglass pool needs resurfacing?

We just finished our pool last month with CA Pools and had our final pool orientation a few weeks ago.

I know we were to expect some mottling with our dark grey and...

looking at installing a new pool in the Toronto, Canada region. Concrete is out of the question due to cost. So I'm left with either fiberglass or vinyl. In todays...

I need to refinish my gunite pool. I've been told that the best time to do this is when it's not too hot. Is this true. I'd like to do it ASAP. It ranges from 95 to 105...

Debating whether to do a 3M finish or PebbleTec. 3M has a 10 year manufacturers warranty vs 5 years on the Pebble. I like the look of the two finishes about the same but...

Hello,
I'm new to this forum and have a painting procedure question.

I am Painting my pool and have 2 expansion plugs on floor to release water pressure under the pool...

Hello everyone,

I recently purchased a new liner for my inground pool. The installers came by yesterday to install the liner and upon removal of the old liner...they...

Hello, I'm from permanentpools(dot)com in Oshawa, Ontario, Canada. I have a question about fiberglass swimming pools. In the winter, they seem to raise out of the...

I am a new pool owner. the home I recently bought came with a 20,000 play pool. It looks like someone dropped a big rock in the pool when it was vacant. Now the hole is...

We have a very old (40+years) pool that has been painted with a rubber pool paint. I just got a pool cataloge that shows "Fusion Plus" that converts Rubber to...

My wife and I are looking to buy a new house. Many of the homes we're considering have pools. The other day some co-workers told my wife about pools needing to be...

BAD PLASTER

can any further problems occur by draining an inground gunite pool other than to the already falling off plaster? May need to leave drained (if I go this...

We are building a beach type pool that will have wet and dry areas. Pebbletec says they won"t warranty for that. What other economical surface can I use for this?

I need to resurface a 25yr old pond in my backyard. It was constructed with bricks and mortar for the shape and then coated with what I think to be plaster. The plaster...

The day the pool company plastered our pool I noticed one big crack across the top of our acapulco stair. We called to see if it was a problem before the pool had...

I have a gunite swimming pool that i took the water out of to acid wash. It rained the next day and the pool popped out of the ground. Does anyone know what the basics...

I drained my gunite pool to acid wash it. I sprayed the sides of the pool with a garden sprayer and the brown discoloration came out beautifully. When I sprayed the...

Hi, we are just finishing up construction of a large pool and have 4 columns rising out of the pool from the step area. We are finishing the pool with tile at the water...

Our pool was recently drained to instal a double-drain system. While empty two 12inch diameter raised delaminated "bubbles" were found on the bottom. (One in...