Pool Pumps, Filters, Plumbing & Piping

1036 topics

Page 52 of 52
- Jump to page:
Previous
1
…
48
49
50
51
52

Topics

Replies

Views

Last post

red/rust muddy water on backwash and filter

by lisa » Mon 20 Mar, 2006 16:46

First post

Please I hope someone can help!!!!!! I am at my wits end. Last winter we left our pool open for the first time in the spring we cleaned out the...

Last post

Hi Lisa

I can appreciate your frustration. You mentioned that

there is no copper, magnesium or any unusal metals in the water

The problem...

1 Replies

2253 Views

Last post by Pool Help
Tue 21 Mar, 2006 03:20
Pool pumps

by Maria » Sun 26 Feb, 2006 15:58

First post

Could somebody recommend a good pool pump. I had a Hayward that only lasted about 5 years so I'm not sure I want to get a Hayward again.

Thanks

Last post

What size is your pool?

What size pump are you looking for?

1 Replies

1520 Views

Last post by Poolz
Sun 26 Feb, 2006 18:34
Pump making noise but not moving water...

by cosmichobo » Sun 05 Feb, 2006 21:15

First post

G'day,

RE previous post concerning leaky pipe...

Over Xmas/New Year I went away on holidays. When I came home, pool was green, and the pump...

Last post

Just did a web search and discovered that the Pantera PPP750 works on single phase so that's not an option.

2 Replies

2442 Views

Last post by Pool Helper
Tue 07 Feb, 2006 13:23
priming

by Agimme » Sun 05 Feb, 2006 15:01

First post

I just replaced the entire pool pump and motor and glued on some new pvc plumbling lines and still the pump won't prime.The motor comes on but can't...

Last post

If the pump is above the pool water level you will need to fill the lines with water first.

Often filling the pump with water will enable the pump...

1 Replies

1564 Views

Last post by Pool Helper
Tue 07 Feb, 2006 13:00
Plumbing question

by msehome » Mon 23 May, 2005 15:18

First post

My contractor install 2 Jandy sheer decent waterfalls and he plumbed them off of the bottom drain suction. They do not go thru the sand filter and I...

Last post

It should have been.

1 Replies

2154 Views

Last post by Poolz
Sun 29 Jan, 2006 14:37
Backwash

by Clearwaterguy » Sun 29 Jan, 2006 06:59

First post

Can you tell me how to backwask a hayward starclear cartridge filter system?

Last post

Unfortunately you cannot backwash your cartridge filter. You will need to remove the cartridges, clean them and then put them back.

Here you can...

1 Replies

1739 Views

Last post by Filter help
Sun 29 Jan, 2006 14:34
Main drain

by Danny » Tue 05 Jul, 2005 10:28

First post

I moved into a home with a 18 X 36 cement inground pool. The pool is 38 years old and I have brang it back from the dead. The pipes going to the...

Last post

Sounds like the check valve (valve with spring) is backwards.

The check valve should allow you to draw water from the pool but not push water into...

1 Replies

2633 Views

Last post by Pool Problem Solver
Sun 15 Jan, 2006 05:47
pool water level rising

by vishal » Sat 15 Oct, 2005 16:01

First post

whenever the filter and pool sweep works, the water level starts rising. My pool is about to overflow because of too much water. Any idea on what is...

Last post

Does the swimming pool have a compensation tank? Where is the extra water coming from? Any ideas?!

1 Replies

3336 Views

Last post by Pool Pumps
Sun 15 Jan, 2006 05:26
Pump Curve

by vaughanwilliams » Tue 13 Sep, 2005 09:16

First post

Can anyone give me best and worst curves for different makes of 1hp pumps?

Last post

Could you narrow that down to specific makes and capacities?

1 Replies

1481 Views

Last post by Pool Pumps
Sun 15 Jan, 2006 05:24
Pump problems

by Kim » Sat 03 Sep, 2005 09:05

First post

HELP!!! Our pump will hold it's prime on low but when you turn it on high it losses the prime. What can be going on?

Please help, we only have...

Last post

Check the o-ring in the pump cover as well as the fittings on the skimmer/ suction side of the pump. The pump may be sucking in air.

1 Replies

2079 Views

Last post by Pool Pumps
Sun 15 Jan, 2006 05:22
high presure low water flow

by yourdarkesthour » Mon 02 Jan, 2006 22:35

First post

i had high presure and low water flow and i did some research and i found out that i should clean my filter. i cleaned the filter and put DE in the...

Last post

This may be caused by scaling or liming of the fabric on the grids, usually due to deposits of magnesium or calcium or both. To clean the grids soak...

1 Replies

2262 Views

Last post by Pool Helper
Tue 03 Jan, 2006 06:54
Gophers and Pool plumbing

by PBArizona » Sun 19 Jun, 2005 17:16

First post

We live out in an area that use to be farmland. I have an underground pool that is less than a year old. I noticed gopher holes in the last few days...

Last post

Can gophers get into the piping by via waterfall and plug system?.

I have absolutly no idea... You should really take it up with a professional.

1 Replies

1947 Views

Last post by Guest
Thu 22 Dec, 2005 22:15
pump doesn't run

by [email protected] » Thu 11 Aug, 2005 18:09

First post

We tried to turn our pump on yesterday but it wouldn't go on. My husband (who is away on a business trip) troubleshooted it with me over the phone...

Last post

Does by any chance, your pump motor have a secondary button fuse built into it? If it was tripped out, you push it back in to reset it. I hope this...

1 Replies

1808 Views

Last post by Cyber36
Fri 12 Aug, 2005 12:01
pool pump motor

by [email protected] » Wed 03 Aug, 2005 09:30

First post

motor is lound and has a droning sound

Last post

Sounds like the bearing(s) have gone. Get a pool man to look at it.

1 Replies

1955 Views

Last post by vaughanwilliams
Wed 03 Aug, 2005 15:24
Pump

by g » Sun 08 May, 2005 20:13

First post

I have been running my pump for approx 24hrs. I did a backwash and now the pump is not circulating water. The motor sounds like it is running but it...

Last post

Sounds like your pump has lost prime. Depending on the height of you pump over water level and other equipment between the pump and the pool...

1 Replies

2396 Views

Last post by guest
Mon 27 Jun, 2005 12:09
plumbing question

by msehome » Sun 22 May, 2005 15:32

First post

Just went thru a remodel on an existing fiberglass pool and my contractor plumbed my jandy sheer desent waterfalls directly off the bottom drain...

Last post

Tell your contractor he does not know what the hell he is doing. These waterfalls have to be on a discharge line after the pool filter going back to...

1 Replies

2477 Views

Last post by B.A.
Tue 24 May, 2005 21:11

1036 topics

Page 52 of 52
- Jump to page:
Previous
1
…
48
49
50
51
52

Return to Board Index

Who is online at the Pool Help Forum

Users browsing this forum: CommonCrawl [Bot] and 0 guests