My multi-port valve is shot. I found a replacement at a pool supply company. The sales rep told me to buy a rubber gasket. Along with all of this he provided me some...

I have an in ground pool and need to replace my Hayward pump. I have an opportunity to buy another brand slightly used pump at a very reasonable price. Both pumps’...

I have a small leak on the output side of the pump where it joins to the PVC pipe. THe caulk(?) is leaking. How can I repair that? I think I can get to the inside of the...

In ground pool.

Hayward two speed pump that ran normally until this morning. Will not run in high speed, but runs fine in low speed?

Capacitor?

when i vacuum the pool, the exact debris I vacuum comes out the jets !

any ideas ?

Hi - I notice a small amount of sand on the driveway every time I backwash so have a few questions:

1) Is that normal?

2) Over time I will need to replenish the...

I need some help with my 20,000 gallon inground concrete pool. My boyfriend is incompetent and is constantly letting it get full of algae and not cleaning it properly....

Hi,

Is it OK to use flexible PVC/vinyl tubing or pool vacuum hose for pool plumbing?? I would like to use the flexible stuff on both the suction and return side, ie....

I have my pool filled and my filter has new DE in it; the problem is, I turn it on, I get pressure for a few seconds (it fluctuates, powerful to light, then nothing). I...

Every time I backwash and then add DE, the returns spit out the DE?? We were told to check the spindle thing inside but it was fine. What else could be causing this?...

This is my first Pool. It is a inground 19x28. The pool was working fine at 15 p.s.i and very good suction, but when I drianed it and refilled it it hasn't ran after...

Yes, when I cleaned the leaves out of the pool with the hose green stuff shoots out the jet. It is an above ground pool with a baquapure filtration system and it is only...

I have a crack in my pipe that comes from the skimmer to the pump. I have determined that it is not far from the pump house but im not sure where the pipe leaves the...

I Have a Jacuzzi Magnum Force pool pump with "an exclusive double Ring-Lok" for "tool-free" access to pump internals. However, I can't get this off....

when pump is turn on the circuit breakers are tripped off in the main circuit box. circuit breakers for the pump do not trip off. anyone has had this problem. Solution?

Someone please help! After mucking with this thing for a week and a half I am about to go nuts!

We have an 18x36 inground run on a Hayward S-200 pump. The pool was...

my above ground sand filter is letting water out of pool through overflow hose,when set on filtration,and controls on top of filter are very loose,what do you...

Help.....Before I call a technician. My pool pressure has been at around 10 for the past week and the polaris won't run. The cleaning system turns on and there is water...

The skimmer has way too much presure. When the basket and float valve (for lack of not knowing the proper term for the thing under the basket) are removed there is way...

I have been struggling with my pool for weeks. My initial problem was that my heater would not turn on. The pilot lights stays lit but that's about it. I have replaced...