My pump has several dials-there are a few I don't know what to use them for. Please help. This is a Hayward Vari Flo XL. The dials are:

Filter - which I run my system...

I have a Jacuzzi brothers ss-160 filter. I took the valve off last night to check the spider gasket. The gasket was worn and needs to be replaced. When I reassembled the...

I just had all 4 of my lines replaced. Had an air leak in the suction side and since I had the returns right below them, I had them replace everything. My question is...

I opened my pool about three weeks ago. Water was fine and very clean. Pressure has been going up a little more than usual, but I thought it was due to just opening and...

I am in a foreign country so it's not always very easy to get help and proper equipment.

I had a non-working pressure gauge on my sand filter that I decided to...

This weekend I installed a Triton II filter and a whisper flo 1hp pump in my 30000 gallon pool. The filter seems to work fine up until I use the backwash. Once I do...

Out of the blue the pump stoppe pulling prime. I resealed all the couplings/fittings expecitng an air leak and still the same occurs.

I can see the water in the...

I'm in the process of changing the pump and filter and am redoing the plumbing. The original system had a skimmer, a deep end water intake and a shallow end return line....

Have an 18 ft AG pool. Had a 1 hp Jacuzzi pump and filter and a lomart skimmer. Pump went bad so changed to a New Hayward power flo matrix 1 hp pump that was new but got...

I just had all my lines replaced but when they re-plumbed the filter, pump,etc. they did not use a quick disconnect on any of it. I always had it that way so that I...

I have a 16x24 kayak pool and If I want to set the valve to bottom drain only it works for about 3 minutes then the hose starts collapsing and then wont flow. Its...

is there a way to seal existing skimmer lines(pvc) with out digging them out ? some kind of sealer you can pour in ? or sleave that will slow down leaks both of water...

I have a hayward pool pump above ground and it keeps losing preasure, it blows out a lot of water for about a half hour and then blows out very little, our fingers in...

I have DE Filter and hayward pump, above ground 18 X 33. I keep losing pressure, it surges then almost completely stops. Someone told me to take the filter apart and...

I have a problem with high filter pressure. I just opened my pool and the pressure went up to 20 psi after about 1 1/2 hours. I bumped it down and it went back down to...

I cant seem to figure it out...I prime, checked for leaks, added more DE and still cant seem to get good water pressure in the filter or exiting.

Anyone have any...

WE JUST INSTALLED OUR NEW FILTER (HAYWARD DE3600) WE DID THE PRE-COAT WITH THE D.E., AND VACUUMED WITH NO PROBLEM ON SATURDAY. I VACUUMED TO WASTE DUE TO THE POOL BEING...

I have a 1hp sand filter for my 21' above ground pool. I just refilled all of the pool water, and now there is hardly any suction at the skimmer, as well as very little...

My hoses do not want to stay attached to my pump. They will work fine for a while, but sometimes when I am vacuuming, the pressure I guess builds up and my hose will...

I have an inground liner pool 16x32, no bottom drain, just the skimmer. Hayward 1hp motor, gas heater, and a sand filter. The pool currently has one return line....