Hi,

Is it OK to use flexible PVC/vinyl tubing or pool vacuum hose for pool plumbing?? I would like to use the flexible stuff on both the suction and return side, ie....

I have my pool filled and my filter has new DE in it; the problem is, I turn it on, I get pressure for a few seconds (it fluctuates, powerful to light, then nothing). I...

Every time I backwash and then add DE, the returns spit out the DE?? We were told to check the spindle thing inside but it was fine. What else could be causing this?...

This is my first Pool. It is a inground 19x28. The pool was working fine at 15 p.s.i and very good suction, but when I drianed it and refilled it it hasn't ran after...

Yes, when I cleaned the leaves out of the pool with the hose green stuff shoots out the jet. It is an above ground pool with a baquapure filtration system and it is only...

I have a crack in my pipe that comes from the skimmer to the pump. I have determined that it is not far from the pump house but im not sure where the pipe leaves the...

I Have a Jacuzzi Magnum Force pool pump with "an exclusive double Ring-Lok" for "tool-free" access to pump internals. However, I can't get this off....

when pump is turn on the circuit breakers are tripped off in the main circuit box. circuit breakers for the pump do not trip off. anyone has had this problem. Solution?

Someone please help! After mucking with this thing for a week and a half I am about to go nuts!

We have an 18x36 inground run on a Hayward S-200 pump. The pool was...

my above ground sand filter is letting water out of pool through overflow hose,when set on filtration,and controls on top of filter are very loose,what do you...

Help.....Before I call a technician. My pool pressure has been at around 10 for the past week and the polaris won't run. The cleaning system turns on and there is water...

The skimmer has way too much presure. When the basket and float valve (for lack of not knowing the proper term for the thing under the basket) are removed there is way...

I have been struggling with my pool for weeks. My initial problem was that my heater would not turn on. The pilot lights stays lit but that's about it. I have replaced...

Just installed pump for aboveground pool brand new out of box,How hot is the pump supposed to get,Not noisy but hot to touch,any help would be appreciated.

We just received a lot of rain. The day after I noticed the pressure had dropped from 20 psi to around 5 psi. I backwashed the pump. When I started the pump back on...

My pool was running fine until I put it on backwash the other day, now a noise is coming from the motor, but the water still runs normal into the filter. Can you tell me...

I goofed and closed the filter without turning off the pump first. We have a sand filter. Almost immediately, the high water pressure from the closed filter with the...

Can someone please tell me what is the correct way of emptying the strainer basket in the pump? I have an above ground pool that is cloudy still. Chemical readings are...

we just purchased a new one hp pump. when I try to backwash my filter system the pump runs hot and trips the breaker. I have to wait until the pump cools off in order to...

I have an algae problem in my pool, have treated it several times with baquacil, after water test at pool store. Two weeks later, still green water. Treated and brushed...