Hi There,

I'm a new homeowner with a pool, and our pool has 2 return pipes/jets that have no eyeball return fittings and I'm trying to figure out how/if I can attach...

After turning on my in floor pool cleaning system, it goes through the same five zones with pressure just over 22 PSI. When the valve switches to the 6th zone the...

Hello, I have a 7 x 3 meter 4 feet pool with a 1.5 hp pump with 2 jet nozzles. The water speed of the jet nozzles coming out near the surface of the pool is barely...

We have a 10,000 gallon inground pool with an attached spa built in 1986 or so. The spa equipment was removed some time ago and we are planning to remove the wall...

My Pentair 1 hp pump died after a little more that one year. I had a spare Jacuzzi pump on hand so ran that for a couple years. Now I find that I was a little late...

Hi
I have a very old Hayward SP-733 (SP0733) Dial-A-Flo 3-way multiport valve. My pump (3 years old) can't maintain siphon once the pool drains down more than a foot. I...

Hello,

I need to remove the multiport valve. Thought the couplings that connect to it were threaded, but 14" channelocks wont budge it. Is it likely cemented and...

Hi,
As I'm about to install a new Heat Pump, I need to relocate my existing Variable Speed Pump and Sand filter to accommodate new heat pump. As currently pump and...

Good Morning everyone. I am new to this forum, and I had a question.

My kids are wanting a swimming pool, and I was thinking of getting this one for them:

I had a...

We are new pool owners of an infinity pool. We have it professionally maintenanced every week. It was serviced Friday and this morning the entire catch basin is empty!...

I have two PVC pipes coming out of the coping on my pool spa - one on each side of the spa facing up. It looks like these pipes used to attach to something because they...

We just had our pool installed. I'm a total n00b and have been reading a lot, but now I'm a little confused by the way our plumbing is configured.

Here's a picture of...

We currently have a Pentair Intelliflo Variable Speed pump. We are looking at replacing it but wanted to know if we could replace it with a cheaper alternative? Our pool...

I have an intex solar heater and want to fill my pool through it to put warmer water in, hoping that I can swim sooner this year. The intex has 1 1/4 fittings, but I...

A few months back whenever my timer started the pump on my saltwater system the pump would not prime and I had to manually add water in the pump filter basket. I ended...

Hi mu Hayward Super Pump has a leak and I can't fix the leak so I'm going to replace it. I note the inlet/outlet connections on the pump are approx 70mm diameter. (See...

Hi,
I want to change the sand of the filter. I tried to find where the drain plug is at the bottom. But I don't see anything at all. Please help.

Sent from my...

Hi, my filter has been leaking from the drain pipe when the pump runs. Pool guy came to fix it and put a ball valve on the end of the pipe, called it fixed (I wasn't...

Hi,

I have a 1.1kW pump on a ~70kL pool, with some weird thing I can't seem to place.

- Suction line remains fine throughout, kreepy runs, no suction leaks (pressure...