Someone please help! After mucking with this thing for a week and a half I am about to go nuts!

We have an 18x36 inground run on a Hayward S-200 pump. The pool was...

my above ground sand filter is letting water out of pool through overflow hose,when set on filtration,and controls on top of filter are very loose,what do you...

Help.....Before I call a technician. My pool pressure has been at around 10 for the past week and the polaris won't run. The cleaning system turns on and there is water...

The skimmer has way too much presure. When the basket and float valve (for lack of not knowing the proper term for the thing under the basket) are removed there is way...

I have been struggling with my pool for weeks. My initial problem was that my heater would not turn on. The pilot lights stays lit but that's about it. I have replaced...

Just installed pump for aboveground pool brand new out of box,How hot is the pump supposed to get,Not noisy but hot to touch,any help would be appreciated.

We just received a lot of rain. The day after I noticed the pressure had dropped from 20 psi to around 5 psi. I backwashed the pump. When I started the pump back on...

My pool was running fine until I put it on backwash the other day, now a noise is coming from the motor, but the water still runs normal into the filter. Can you tell me...

I goofed and closed the filter without turning off the pump first. We have a sand filter. Almost immediately, the high water pressure from the closed filter with the...

Can someone please tell me what is the correct way of emptying the strainer basket in the pump? I have an above ground pool that is cloudy still. Chemical readings are...

we just purchased a new one hp pump. when I try to backwash my filter system the pump runs hot and trips the breaker. I have to wait until the pump cools off in order to...

I have an algae problem in my pool, have treated it several times with baquacil, after water test at pool store. Two weeks later, still green water. Treated and brushed...

my filter and pump were running just fine until a few nights ago. when i looked at the pool the other morning the pump was running, but no water was being circulated. i...

I have a hayward finger type DE filter. when I opened the pool it worked fine for about 10 hours then the pressure went up and I "bumped" the filter. In about...

We have a spa that is at a higher level than the pool, and during the filter cycle will drain into the pool (slight waterfall). After the pump stops, the spa is...

My pump is running on low and water is clear turn it on high and it blows out a film of white dust seems like.....I am constantly back washing to get the dust out.....I...

I posted this in cloudy water by mistake...above ground, hayward sand filter..has overall poor suction when using vac., backwash doesnt shoot out far and fast like...

My filter and pump works fine until a hook a vaccum hose to the skimmer. As soon as I hook my cleaning hose to skimmer it sucks down real tight and the pump backet...

I have an above ground pool.

With sand filtration system. when i turn on the filtration the water is initially sucked through the skimmer, then within 30 seconds or...

Hi. We are adding on to our deck and to make it easier to reach the filter for backwashing, etc, we moved the pump/filter further away from the pool by adding on hose...