Pool Pumps, Filters, Plumbing & Piping

1036 topics

Page 10 of 52
- Jump to page:
Previous
1
…
8
9
10
11
12
…
52
Next

Topics

Replies

Views

Last post

Pumps

by kojo » Sat 01 Jun, 2013 23:10

First post

I have a Hayward Power-Flo 1hp. when I plug it in all it does is hum. When unplugged I can turn shaft by hand
but when I plug it in and try to turn...

Last post

Thanks TSH Tech, I'll check that tomorrow . Where's a good place to get a capacitor or do you think ordering
one online is my best bet. They aren't...

2 Replies

836 Views

Last post by kojo
Sun 02 Jun, 2013 23:07
Solar Panels

by Guest » Wed 29 May, 2013 17:46

Hello..I am new to forum, and was hoping someone could help me out...I have an above ground 12X20 pool, that i recently put up 2 sungrabber 2x20...

0 Replies

452 Views

Last post by Guest
Wed 29 May, 2013 17:46
Air pressure explosion

by Sally » Wed 15 May, 2013 13:58

First post

I have an above ground pool with sand filter and heater. I went out to clean filters, turned off pump and the skimmer bucket and lid on side of pool...

Last post

That is caused by a build up of air in the filter which is caused by a suction side air leak and most often is the pump lid leaking. Try a little...

3 Replies

2245 Views

Last post by Sally
Tue 21 May, 2013 10:06
Pump won't stay primed, pipes making a whooshing noise

by allilo » Tue 21 May, 2013 09:06

I have an in-ground, 25,000 gallon single level pool. Opening went great until I was finishing up the last bit of the opening cleaning routine. My...

0 Replies

1172 Views

Last post by allilo
Tue 21 May, 2013 09:06
Broken Backwash Piston

by IAMFOODMAN » Sat 18 May, 2013 09:24

First post

Hello,

Brand new to the forum and a second season pool owner. The backwash piston broke on my pentair sand filter. It is the bottom disc and ring...

Last post

Hello Foodman,

If you could provide a photo of the valve, that would be a help. I think the bottom pipe is the backwash line, which should stub out...

1 Replies

590 Views

Last post by CGPoolman
Sun 19 May, 2013 07:40
Sand filter leaks

by rld7 » Wed 15 May, 2013 20:52

First post

My sta rite crystal flo sand filter is leaking from the top. I was looking at the schematics of the sand filter on line and it looks like there is a...

Last post

If water is leaking from the backwash line, this is usually due to a bad "wagon wheel" gasket inside the multiport valve. With the system...

3 Replies

2210 Views

Last post by CGPoolman
Fri 17 May, 2013 08:08
Problems with zeobrite or zeobest
1

2

3

4
by azpoolpros » Fri 22 May, 2009 20:22

First post

Every pool that I have ever serviced with zeobest, or zeobrite, has had nothing but problems.

Example:

Drained a pool due to green water plus it...

Last post

Opened my pool two weeks ago. The zeobrite was put in July 2011. I live in Minnesota so the pool is only running May-Oct. I had algae problems and...
31 Replies

33130 Views

Last post by garymbos
Thu 16 May, 2013 13:34
Return line threading - Am I being told the truth?

by pooldaddio » Mon 29 Apr, 2013 13:08

First post

Hi. I'm a pool "newbie" and just noticed that the Universal Wall Fitting is not screwed in all the way to the return line on my new pool....

Last post

This is my second pool opening. I made the mistake this year of tightening the threading on the cleaner connector and now have to replace it since it...

2 Replies

976 Views

Last post by barbarahb
Sun 12 May, 2013 15:41
Not Laterals - but sand in the pool

by neville » Sun 05 May, 2013 10:33

First post

Last year before close up I noticed very fine sand in the pool. After research and opening the pool this year I continue to see more. Thinking it was...

Last post

Thanks for all the help. It was not the laterals but was the spider gasket as suggested. The sand was getting under the gasket. It had literally turn...

3 Replies

7562 Views

Last post by neville
Sat 11 May, 2013 13:21
Pump runs but nothing happens

by gelidus » Tue 07 May, 2013 20:59

First post

I have a 30k gallon pool. When I prime the pump the water flowns from the basket to the filter but that seems to be it.

When I put it on...

Last post

Ill go out and put soapy water at various pipes see if it sucks any of it in.

Would a pic of the filter and heater help at all

4 Replies

1538 Views

Last post by gelidus
Thu 09 May, 2013 10:34
Pump Strainer Housing Leaking Water

by exilegod » Wed 08 May, 2013 19:24

First post

Hey guys, my pump strainer housing is leaking water, im not very techincal with this stuff but what im trying to say is i have the following pump...

Last post

Pretty vague explanation of the leak. So I'll go through all of the scenarios:

- Pump pot lid O-ring is worn, leaking when pump shuts off, replace...

1 Replies

1683 Views

Last post by TSH Tech
Thu 09 May, 2013 03:18
Pump on but no water pumping out

by exilegod » Tue 30 Apr, 2013 19:28

First post

Hey everyone,

it was really windy outside yesterday so i turned off my pool's pump. However, today when i went to turn it back on , the pump came on...

Last post

thanks it worked!

3 Replies

930 Views

Last post by exilegod
Wed 01 May, 2013 17:18
Debris and Pressure

by michealcell » Wed 01 May, 2013 16:56

I'm having an issue with debris in my pool and I don't think the filter is filtering it or maybe something else is going on. I opened the pool 2...

0 Replies

388 Views

Last post by michealcell
Wed 01 May, 2013 16:56
New DIY Pool. pipe & plumbing design help required

Attachment(s) by jodal666 » Sun 21 Apr, 2013 07:05

First post

Skimmer design (Copy).jpg Hi all.
New to the forums. looks like there is some good info here.

hope I'm posting this in the right place.

I am...

Last post

Hello, if I may offer a suggestion. The following plumbing diagram shall give you the best of all worlds, enabling you to independently control each...

1 Replies

1145 Views

Last post by TSH Tech
Mon 22 Apr, 2013 01:36
Suction side issue?

by darins10 » Mon 25 Mar, 2013 10:58

First post

I'm new to the forums and after searching, I am still unable to troubleshoot my problem.

I can't seem to get my pool vacuum working to what it was...

Last post

Hi
Have you tried silicone grease on the "O" ring to the lid of the pump basket. It allows the lid to tighten down more
Even new...

1 Replies

1108 Views

Last post by Denniswiseman
Fri 19 Apr, 2013 06:41
What type of pump should I use?

by grasslizard » Wed 10 Apr, 2013 10:23

First post

I am constructing a small splash pool in my garden. It is rectangular, made of concrete and measures 16' x 8' x 4' which gives a volume of approx...

Last post

In my opinion - I still would not go with any less than a 3/4HP. If anything, I would go with a 2 speed pump. Run it on high for a few hours to...

3 Replies

1709 Views

Last post by CGPoolman
Thu 11 Apr, 2013 08:29
High Filter pressure
1

2
by mfour4 » Thu 21 Mar, 2013 14:26

First post

Hi there folks
I need help with a problem of high...very high pressure 35 to 40 PSI in my filter system.
The insides are new as of yesterday but I...

Last post

Well after cleaning out the filters.....( removing them etc ) and starting up again pressure has remained at 20 since......all is good!!
Thanks for...
11 Replies

15765 Views

Last post by mfour4
Fri 29 Mar, 2013 10:52
Pool and Pump

by jjackson07 » Fri 01 Feb, 2013 13:44

First post

I have a 13 year old Viking Pools fiberglass Cape Coral pool which is 10' x 20' and holds 3,750 gallons. It is currently pumped by a 1 1/2hp Hayward...

Last post

Hi I just wanted to give you an update.

I've installed my new pump and filter and they work like a charm with my solar pool heater!! The water is...

4 Replies

2603 Views

Last post by jjackson07
Fri 29 Mar, 2013 10:50
Loss of Prime

by larcrow » Sat 16 Feb, 2013 20:54

First post

My pool pump (Sta-Rite Max-E-Pro P6EA) with an Integral Trap) has difficulty attaining the proper flow when it is started after being turned off...

Last post

If the pump basket is draining out - there's got to be a leak somewhere. Do you have any 3-way valves in front of your pump? These are a common...

4 Replies

1699 Views

Last post by CGPoolman
Thu 21 Mar, 2013 10:49
Poor suction after storms

by Rmleboeu » Sat 16 Mar, 2013 12:21

I'm stumped, and need help. I have a 20k gallon concrete in ground pool with 300lb sand filter. I have three suction lines: skimmer, main drain, and...

0 Replies

474 Views

Last post by Rmleboeu
Sat 16 Mar, 2013 12:21

1036 topics

Page 10 of 52
- Jump to page:
Previous
1
…
8
9
10
11
12
…
52
Next

Return to Board Index

Who is online at the Pool Help Forum

Users browsing this forum: CommonCrawl [Bot] and 0 guests