I just installed a new century 3/4 hp pump motor. When I try to prime the pump the pump gets hot and shuts off. The basket fills up, the pressure relief valve is sending...

I googled, watched YouTube videos, and even purchased removal tool to prevent this from happening. I put the tool on the fitting and the universal fitting crumbled.

My...

I'm looking for some input on my plumbing pipe size for my new pool (20x40, 25,000gal, 2 skimmers, 4 returns, sr slide, 4 deck jets)(ecostar pump, c4030 filter, h250...

Cranked up a pool that has been sitting uncovered since last season. Everything was going fine for a couple days, now skimmers are not pulling water. If I backwash they...

hi i have an inground gunite pool built in 2006 to florida codes with duel main drains. i have the pool drained for cleaning and thought i would install a Hayward SP1056...

Hi my salt water poolrite control unit momentarily switches off on effecting the chlorinater new chlorinater fitted builds slowly then stop starts pump and cycles again...

Hi,

I have a question about learning about the pool system

If the Maximum Flow Rate for 2 inches PVC pipe is only 45GPM and i only use 2" pipe for my pool
Am i...

I am looking to design/install a new set of sand filter, pump, solar pump , waste, 2x pool outlets, 1x pool inlet based on 50mm pressure pipe network.

I am looking for...

When vacuuming the pool all the dirty water is sent back to the pool jets. I have replaced the sand, replaced the spider gasket. The sand stays clean. When I backwash...

Hello folks. Today I dismantled my pump as it had a stone stuck in one of the fins. I removed the stone and the pump failed to re-start. I prompted it and it began but...

Dear Pool experts,
I need help with the following:

I have a rectangular pool of 11,000 gallons and recently the motor of the pump went bad. The specifications of the...

Hi,

I've just moved into a house with a pool. I've never owned a pool before but I am an Engineer so getting to grips with the equipment with references from this forum...

I currently have a 3/4 hp whisperflo. It started to make noise due to the bearings, so I called home warranty to repair it since I just bought the house couple months...

Hi,
I've had problems with my creepy not moving properly, pool basket not filling up all the way to the top and air bubbles being sucked in the swimming pool for over a...

The water intake for my negative/infinity edge catch basin is waaay below my pump, maybe 10ft. The pool installers warned me that this would lead to difficulty priming...

Hi,
I have a 24' agp, Hayward Pro Grid DE 2420 filter with MPV = Hayward S710XR50.
When I opened the pool in June, I backwashed and no dirty water came out. A few weeks...

Hi, new to the forum after recently moving to a new house with large indoor inground concrete tiled pool.
I am trying to identify the design of the sump drain. All other...

So the suction is not as good as it should be. We have a net that goes on basket that collects all the little stuff. Before you couldn't even pull the net up while pump...

Hello, I've been helping my next door neighbor with her pool (new as of this season). But we made a mistake today. After we added a chlorine tablet to her chlorinator,...