when i turn on the filter, the pressure gauge is still on zero and i dont see any water running, i only hear the motor running... please help

I need to replace the PVC pipes on the inlet and outlet of my pump. They are labeled as 2 inch schedule 40. But, the 2 inch schedule 40 fittings I bought don't fit. Any...

My wife and I are in the process of purchasing a home with a pool. The electric inspector noted that the pool pumps are not grounded, and commented that that probably...

Hello,
First time user, but I've skimmed all of the topics in this section and haven't seen a problem like mine posted yet. I bought a house with an in-ground liner...

Hi

Can anyone suggest the best PVC pipe cement to fix a leaking lasco 1.5 inch pipe joint in Florida please?

It's been "fixed" with pipe weld for the last 5...

Hi,

Looking for help ID'ing an extra pipe (new pool owner). I have an inground pool and can't figure out why I have 4 pvc pipes going into the ground near the filter. I...

Afternoon, THis is my first time posting so I appreciate any ideas.
I have had an inbound swimming pool for 11 years, 10 without issue. This year my pressure after...

Hi all and thank you in advance for any help. I replaced my 10 year old motor with a new 3/4 hp after it started squealing. The new A O Smith motor will run for approx....

A 14 inch piece of pvc pipe was inadvertently sucked down one of the skimmer tubes (there are 2 skimmers in the pool). The dropped pvc pipe was only slightly less in...

Hello, I made my question into a video so you can see more clearly what my question is, please click on youtube link to view and thanks for any help!
Video below

Hi all!

I have recently bought a house and inherited a swimming pool in the process. This is proving an incredibly efficient way of getting rid of my money (boiler was...

Turned pump off last night and tried to turn it back on this morning and it just makes a noise but nothing else happens then it throws the breaker. I think the motor has...

Screen Shot 2016-07-30 at 18.16.43.png Screen Shot 2016-07-30 at 18.16.43.png Screen Shot 2016-07-30 at 18.16.43.png

Hi there guys, i'm a total newbie sorry and i'm...

In an attempt to save some money on energy cost my wife and I purchased a new Pentair VSP pump. I am running into issues with programming the different speeds. It...

Hi,

Recently, I have cleaned my filters on a Sta-Rite systems3 filter system. I changed the O-Ring on the bottom plug. I could not find any o-ring for the side plug...

I'm running a Pentair Triton II model TR60. Inground pool. I backwash the system 3-5 minutes following the directions on the label. Rinse the system for 30 seconds, then...

Hello everyone, i got a issue maybe this forum can help me with. My flow sensor for my aqua rite system cord is cut. I dont want to buy a new flow sensor if i could fix...

Our Hayward pump says "Drive Error" "Pump has Stalled."
The pump was working fine and our pool maintenance company connected our new Polaris. The...

Hi,
I am looking for someone to help me with one of my pipes. My pool was set up so that the water would run through the filter, heater, chlorinator, back into the...

We are adding an SR Smith Turbo Twister slide which calls for up to 25 gallons per minute of water. Here is a picture below of my pool equipment and I have a few...