Hi,

Our pool, in the dark ages of 3 years ago, seemed to use an Intermatic PE24VA valve actuator to automatically switch between the skimmer and the in-floor popups....

Hello all,
This is my first post so I hope I am in the right place. I have a Pentair Intelliflo Variable Speed pump that the speed drive went out on. Does anyone know if...

Hi there,

Its my first post in the forum, first week learning about pools and have read most related posts here, so please excuse my ignorance :D

Pool:
100 squared...

18 x 36 in ground pool new to me, got it cleaned up and now working on getting pump and filter working.

if I fill the pump basket with water or have a garden hose...

we've come to the conclusion that my current filter setup simply does not flow enough water for the 18,000 gallon pool, plus spa, plus tanning ledge. I have a 2 HP pump...

Hi there. After hearing a dripping next to our pool, we discovered that one of the return pipes seemed to be leaking. The pipe goes to the jet, but there is a section of...

I have a 20,000 gallon, chlorine pool with a 2hp single speed Hayward pump AND a Pentair electrical heater (heat pump). I'm thinking of switching to a VARIABLE SPEED...

Husband went to replace pressure gauge. Unfortunately, the gauge’s threaded shaft, broke and part of it is stuck in the filter. Now we can’t put the new pressure gauge...

I have bubbles coming from the bottom drain inlets when the pump is running and the line is partially valved off. The pool is 8'deep. The more I open the valve the more...

Hi

Does anyone have experience with magiline pools (with their fx30 filters and fxv motors)? I'd like to sense check something.

The pump has no suction side. It's...

Hi,

I've got a new pool and a whole new system. Yesterday, I connected the pool pump on the Pro Logic electric board. I started the pump in backwash mode. It was...

Last week my pump started making a much louder and higher pitched sound than usual. I assumed it was a bad bearing and shut it down. I had someone come out and quote me...

I have a four foot above ground pool with a small sand filter and pump. I took pictures of my equipment but can seem to upload. I found an almost identical system on...

Hi, hoping someone can help. With no Kreepy Krauly attached in our pool, the pump & filter work perfectly. Pressure sits at around 13 pounds, and there's no air...

Hello, pool experts! I have an issue that my pool service contractor hasn't been able to solve.

First, some context: I have a 21000 gal in-ground gunite pool with a...

Any suggestions on something similar that won't break the bank.

Sent from my SM-G975F using Tapatalk

Our houses pool was built in 2008.
We have the 2 inch round jet nozzles around the pool but, what are these large round ones for? Can't tell if they work or what they...

Hello, my name is Jack and I've had my pool for about 15-20 years now. It has undergone a lot of maintenance under the years. The current sand filter I have in place was...

Hello,
My Jandy pool pump died and bought a replacement pump (a Hayward pump)
The new pump connects to 2" pipe and my current pool pipes are also 2" but they...