I was wondering if anyone could tell me why on startup my system is blowing a lot of air back into the pool and then what appears to be either millions of tiny bubbles...

It has been several years since we've opened our pool and we've run into a problem. There used to be the following pictures setup and working, but it seems the wires...

Started up pool for the season. No leaks, air etc. When I held my hand over the return jets the pressure or flow was low. Usually it will push your hand away strongly....

I have an american products pool pump. I am trying to remove the moter and impeller and the nut recessed in the housing is rusted and is rounded off. Do any of you have...

Hi
Im a new pool owner. I was learning the basics of the system when I noticed a leak at the top of my Waterways Crystal Clear DE canister at the bleed valve. While...

I just replaced my filter and pump. On first start up pressure reads 19 with good return flow and good suction on both skimmer and side wall suction lines. After a few...

My pressure is about normal running stong at 16 to 18psi but after 20mins or so it will climb to solid 20psi and i seem to lose suction and i get less flow. If i bump it...

I just changed the top 1 1/2" of sand in my filter and for some reason I cannot now get the top back on in it's proper place. It seems to be about 1/4" too...

Ok, not sure where to start. I have an in ground pool with a DE filter and 3 lines (main drain, skimmer and dedicated vac line). My vac line poor suction and crap is...

I have a 25'x50' inground pool. It is about 56,000 gallons and located in S. Florida. The pump and filter needs to be replaced. The pump is rusted out, filter is split....

I am having a problem with the return to my inground pool. The pressure in my filter reads arount 35 to 40 but nothing is being returned to my pool. I have replaced...

I was reading on this forum that when doing manual cleaning it is a good idea to turn off 1 skimmer and the drain valve in the deep end, so I can get maximum suction...

We've had our pool for about 4 years now. We bought from RecWarehouse and it's great, but we're on our 2nd Filter and about to go to our 3rd! I'm not sure if they're...

Hello - just joined as I am having problems in getting to grips with a problem we are having.

In ground pool, with a Sand Filter. I recently vacuumed the pool, and did...

After maintained my Purex SMBW 2048 DE filter (open the lid, remove the manifold, etc.), It developed the leak through the drain at the bottom of the filter when the...

I'm a volunteer pool operations person for 72K gallon neighborhood gunite pool.
We have a Polaris C-660 controller for the main and for a 2.3K gallon wading pool.

The...

The plastic rings that retain the return nozzles have seized. I got a bit of movement with huge Channel Locks, but afraid of breaking something. Are there any...

Hi. I have a very old concrete pool. I having the liner replaced, it's already out of the pool. The coping around the pool are old masonry sections on top of the...

I have a smallish pool with a Caretaker pop up cleaning system, and a sand filter. Recently I noticed extremely high pressure on the filter when the cleaner is set on...

On my goldline controls, it says "check flow switch" on the screen. I thought it was my salt cell, but I cleaned it and it looks like it did when I cleaned it...