I have a San Juan Catalina fiberglass pool, approximately 26X12. It is a kidney shaped pool. The 2 return jets are placed on the step (shallow) end of the pool. What is...

Suppose, hypothetically, you held the end of the pipe from the main drain higher than the level of water in your pool and opened the valve at the end. Would the water in...

Hello I'm new to this forum, and this is my first post.

My return valve broke so I had to buy a new one. I went to my local pool shop, to get one. They said it was a...

It looks like I have a small leak where the Sand Filter Body and the Multi-Port Valve meets. It appears it may only leak when the Filter is running, I do have to jiggle...

Recently replaced by lateral assembly valve in my Hayward sand filter. Now when I turn on my filter i have a small stream of water that constantly escapes thru my...

sun has bleached all the labels on valve,not a great memory. its a baquapure 26'' from rec warehouse that say 7 valve mutiport....any help would be appreciated?

I finally was able to start opening my pool yesterday. Hooked up everything but some o rings in the pump and filter fittings need to be replace before I can go any...

I was wondering if anyone could tell me why on startup my system is blowing a lot of air back into the pool and then what appears to be either millions of tiny bubbles...

It has been several years since we've opened our pool and we've run into a problem. There used to be the following pictures setup and working, but it seems the wires...

Started up pool for the season. No leaks, air etc. When I held my hand over the return jets the pressure or flow was low. Usually it will push your hand away strongly....

I have an american products pool pump. I am trying to remove the moter and impeller and the nut recessed in the housing is rusted and is rounded off. Do any of you have...

Hi
Im a new pool owner. I was learning the basics of the system when I noticed a leak at the top of my Waterways Crystal Clear DE canister at the bleed valve. While...

I just replaced my filter and pump. On first start up pressure reads 19 with good return flow and good suction on both skimmer and side wall suction lines. After a few...

My pressure is about normal running stong at 16 to 18psi but after 20mins or so it will climb to solid 20psi and i seem to lose suction and i get less flow. If i bump it...

I just changed the top 1 1/2" of sand in my filter and for some reason I cannot now get the top back on in it's proper place. It seems to be about 1/4" too...

Ok, not sure where to start. I have an in ground pool with a DE filter and 3 lines (main drain, skimmer and dedicated vac line). My vac line poor suction and crap is...

I have a 25'x50' inground pool. It is about 56,000 gallons and located in S. Florida. The pump and filter needs to be replaced. The pump is rusted out, filter is split....

I am having a problem with the return to my inground pool. The pressure in my filter reads arount 35 to 40 but nothing is being returned to my pool. I have replaced...

I was reading on this forum that when doing manual cleaning it is a good idea to turn off 1 skimmer and the drain valve in the deep end, so I can get maximum suction...

We've had our pool for about 4 years now. We bought from RecWarehouse and it's great, but we're on our 2nd Filter and about to go to our 3rd! I'm not sure if they're...