My Jacuzzi filter is leaking out from around where the valve assembly (7-dial) bolts onto the adaptor flange. I've replaced the square ring gasket. It's not just a drip,...

I have an 11000 gal pool with a 1 1/2 hp pump and a Hayward filter system. It's about 10 years old.

I've been having problems with green/off-colored water. After...

the pool came with house, and no matter what i do i can not get the filter to be silent. it always sounds like there is air in there.

i have replaced all my...

The guy that used to open and close my pool stripped the threads that the Polaris adaptor screws into the
side of the pool.
How can I fix this?
Gunite pool by the way....

Opening pool after 3 years. Replaced bad hoses.
Won't prime.
Changed rubber gasket on motor cover. No change
When I turn the motor on a mixture of water and bubbles make...

Trying to get our pool opened. Pump works fine--it's new. But when we have it running to the sand filter, every thing stops!!! Pump is pumping virtually NO water and...

We are installing a UV system for our pool, and the manufacturer recommends a max flow rate of around 50gpm. There is not enough room to install a flow meter, but there...

When pool was opened this year, main pool pump wouldn't start, pool company found the interior switch melted, and replaced pump. 3 weeks later, my Polaris Booster pump...

Hi, I'm new to this even though we've had the pool a number of years. I have a 12 x 18 above ground pool for which I just bought new 1.5 HP filter pump. When I turned...

Hi Guys, I am new to this forum, but I hope somebody can help. Last season I noticed sand being put into the pool by the filter (Tagelus 40). So this weekend I emptied...

The facts:
1. Pump runs around 20 - 25 psi. Ok??
2. Two returns, two intakes (skimmer and main drain). Generally I just use skimmer and sometimes switching between them...

I have a Hayward Power-Flo 1hp. when I plug it in all it does is hum. When unplugged I can turn shaft by hand
but when I plug it in and try to turn it by hand it won't...

Hello..I am new to forum, and was hoping someone could help me out...I have an above ground 12X20 pool, that i recently put up 2 sungrabber 2x20 solar panels..

When I...

I have an above ground pool with sand filter and heater. I went out to clean filters, turned off pump and the skimmer bucket and lid on side of pool along with air and...

I have an in-ground, 25,000 gallon single level pool. Opening went great until I was finishing up the last bit of the opening cleaning routine. My pool was installed...

Hello,

Brand new to the forum and a second season pool owner. The backwash piston broke on my pentair sand filter. It is the bottom disc and ring that has snapped off....

My sta rite crystal flo sand filter is leaking from the top. I was looking at the schematics of the sand filter on line and it looks like there is a washer under the...

Hi. I'm a pool "newbie" and just noticed that the Universal Wall Fitting is not screwed in all the way to the return line on my new pool. It sticks out and...