Ok...so I haven't invested a lot of time in learning about our pool but have repeatedly throughout the years troubleshot each problem or question upon inheriting it in...

I noticed that my pump was losing prime whenever it shut off. I took advantage of needing to change the filter to see if there might be a problem with the Hayward Filter...

Hello All,
I Replaced The Pump Seal On My Hayward Pool Pump. The Leaking Is Now Gone, But The Pump Sounds Extremely Loud And High Pitched. It Is Pumping Water Fine But I...

I can't understand why my hayward power flow lx's skimmer basket is not filling up and if it does it surges and go's back down I have enough de and I I let the air out...

I can't understand why my hayward power flow lx's skimmer basket is not filling up and if it does it surges and go's back down I have enough de and I I let the air out...

My main pool pump has starting acting very strangely. When it comes on in the morning it will work for about an hour delivering plenty of water to the spa which then...

hello i was wondering our pool pump cord got ran over by the lawn mower :roll: its just a smaller type pool from walmart but to replace the pump would cost a little over...

Looking for some clever suggestions. The base of my pump motor has rusted off, therefore there is no way to attach it to the plastic base. Its old but works fine and I...

I have an in-ground pool with an attached in-ground spa. There are two main drains on the floor of the spa. During winterization, both drains in the spa were plugged...

I am trying to re-connect my above ground pools pump motor but needless to say Im not sure the correct wiring pattern. I believe the brand of the pump motor is a...

Hi guys I have a question about check valves. I have to re plumb my filter because both my check valves went bad. The one that goes to the solar heat pipe is already...

When my in-ground pool was installed in 2001 the installed put in a pipe from the pump area to the side of the pool to be used for a full-time suction line for an...

Last year before we closed the pool, we had noticed a lot of sand coming from the return jets back into the pool. We had the laterals changed, sand replaced and a new...

while installing a new pump for my neighbor, I noticed the position of the black 'selector' connector with two wires does not line up well with the 110/220 label on the...

Hello, As my username suggests, I am a pool novice. Last winter I removed my Hayward pump (Power line 1HP) to keep it dry, making a note of the connections etc. Now I...

I am trying to understand the right times of the day and durations to run my filter pump. I am using the BBB approach and like to add chlorine at night, when it is...

I have 2 pool drains at the deep end of my pool, that I can't figure out what they are there for. The reason why, is because my plumbing setup doesn't have any pipes...

Hello all,

I am a pool homeowner and I have a pool power problem. Any help is appreciated.

Hello all,

We just bought a home with a pool about 8 months ago and so we are still definitely learning and trying to do most of it ourselves. I'm hoping someone here...

Help!!!!!

Everything working perfectly. Breaker turned off to replace manifold in Hayward cartridge filter. Repair completed by my pool guy. No one touched anything...