Hi everyone!
I've got some problem (obviously) with my pool. The sand in the filter is new, the pump is new.
In-ground pool, 75k of water, 3 return lines, Hayward Super...

Hi guys, newbie here. We recently got an inground saltwater pool with spa built. It’s about 12K gallons. Pentair equipments (EasyTouch ScreenLogic, IC40 SWCG, and...

I'm really having a hell of a time this year with the pool opening. Meanwhile, my pool is turning into a pond.

I finally got my variable speed pump going (huge rookie...

Greetings,

Pool company when closing took off the old failing three way ball valve (skimmer, bottom drain, pump filter basket). Two lines are 1.5" male threaded,...

Hi everyone. We have a 24’x 52” tall above ground pool for the last 15 yrs. I’ve replaced the Hayward d.e filter motor 2 yrs ago. Last yr I noticed the pump not...

Hi folks. I have an unusual situation with my Aqua Genie skimmer. There is flexible PVC pipe glued into the fitting for the suction line. I seem to have an issue with it...

I am in need of some guidance on installing the Strainer Pot Housing piece to my pump. My pool is still full and I have not done anything else to the pump. My problem...

We just installed a new sand filter on our 24x54 round pool.. ran it day 1 on high.. turned it to low for over night.. the next day if we put it on filter high water is...

Hello Everyone,

I have a 28,000 Gal inground salt water pool running on a DE Filter with 1.5HP Hayward pool pump. The pump does a good enough job running the jets but i...

I could really use some help with this one, I'm on my second week of trying to get this hot tub working.

Setup
All my hardware (and the in-ground hot tub) came with...

I have AQUA Logic Display and a Hayward Goldline Aqua Logic Main Circuit Board GLX-PCB-MAIN

It controls two actuators which turn on the fountain jets and are connected...

Hi everyone. I just purchased a used variable pump to replace my Hayward super pump.

I connected everything and it powers up but there is nothing on the screen. The...

My pool pump just went bad..it was a Hayward superpump..thinking about going to variable speed pool pump but can't find any info on if I have any options without going...

Hello, The top image is a water deflector. It goes on the motor shaft. The bottom image is a thin wavy metal spacer from the Hayward power flo lx 1hp motor. I am not...

Just bought a home recently and want to re-build the plumbing for my in-ground pool. Right now it's hideous, with black poly pipe hanging in mid air and some flow...

hi everyone, we are having a very small fiberglass “cocktail pool” installed - its only 1200 gallons, about 7ft by 9 ft. The contractor has lots of experience installing...

Hi I recently replaced a Hayward Star Clear C500 filter for my 450 gallon inground marcite spa. The old one was leaking from the top (even after replacing gaskets etc.)...

Hi everyone,

I have an AquaLogic / GoldLine / Hayward AQL-P-4 Logic Control Board that was working fine when I closed my pool last year. When I tried to open it a few...

so last year we changed out our sand in our sand filter. worked fine all summer. fired it up two weeks ago and the water is still as cloudy as it was when we opened the...