Hi all,

I'm new to owning a pool and could use some help. I'm battling an algae problem the previous owners had let get out of control. I would like my pump to run 24/7...

Investing in an Above ground swimming pool sand filter which is reliable and durable would be the best if you are planning to construct an above-ground or in-ground...

I have noticed that everytime my pump comes on for the day it has to reprime...also getting air coming from returns several times during the day. Any help? Thanks a...

Hi there, we have a 10 foot pool which we bought from argos. Its the 10 foot neighbourhood swim centre. We bought a filter pump for it. It's 330 Gallon Bestway flowclear...

I have a 5,000 gal. underground pool with attached spa. The pump is a 1.5HP Hayward Super Pump and the filter is a Hayward 210T filter, which has sprung a leak toward...

We have an Intex pool. It is 24x12x5. 10,772 gallons and 1440 cubic feet. The salt water filter and pump broke and looking for another type. Any advice on what will be...

For some reason our new Intelliflow runs, fortunately at low speed, during the 16 hours is supposed to be off. Of course the electrical drain is minimal, this modern...

Ok, my pump motor was screaming, so I know it was about to quit. Two days before my son blew off the leaves off the roof of the house, so damp leaves feel on the pump....

We have an older 16x32 ft inground pool. While vacuuming it ther other day this part fell out of the hose. No idea what it is.. help?! :?

I know nothing about pools so this is probably a stupid question but how do you turn a pool filter on? My dad is away (internationally so I can't reach him) and he said...

My Hayward pool pump starts out with 18 psi and then after 30 minutes the pressure goes down to 12 and then later down to 8. The motor is real quiet in the beginnibg and...

I would like to throw my hayward valve in the trash can. It's cracked, leaking, and expensive.
How about replacing it with a series of ball valves.

My pool pump ( the motor part) is SUPER hot, almost burning to the touch. The skimmer is empty and when I vacuum there's great suction. Is this normal or should I be...

I replaced my 1hp pool pump with 2" inlet with a new 1.5hp pump with 2.5" inlet. My new pump continues to overheat and burn up the motors (3 of them in 3...

I have a Hayward pump and filter. When it first goes on the suction is strong. After about 30 min the suction starts to decrease. The pressure does not go below 15-18...

I have about 3 pounds of pressure on my gauge. Small, new, inground pool, sand filter, etc. Have checked plumbing, motor, impeller, no obstructions anywhere. Sand filter...

I just refinished the concrete portion of my kidney-shaped pool, bought the new filter system and have since discover the return line is leaking a large amount -...

The water through the skimmer does not get filtered. (skimmer, pump, in-floor cleaner valve, in-floor cleaner nozzles) We do use a skimmer sock. Would it be feasible to...

When I backwash, the water is clear. If i tap on the drum, i see some cloudy water. However, when I open the drum, the grid is filthy with earth. Could it be possible...