Pump picks up ok. when it turns off for a period, sometimes looses prime. I also hear water gurgling through the sand filter valve. Should the cell hold its water when...

The label on my Sand Filter has faded so bad I cant see it. It is a Hayward S160T Sand Filter, the only label i can read is the backwash. any diagrams or pictures would...

Hi there, new to the forum and to owning a pool. Just bought a house, don't know much about the existing system. Here's what I know, 17K inground pool with 2"...

Hey all, this is my first post here, so thanks in advance for any advice and information given to this pool noob.

I just got a new Hayward 1HP Super Pump to replace my...

When I attach the vacuum to the skimmer, I lose the prime for my pump. Sometimes it starts back up on its own, sometimes putting the hose into the skimmer starts it....

We have an older pool, we drained it this year and painted it. After the fill, we noticed only half of our spa jets we working ( four out of eight ) with two blowing...

All through my youth we had an above ground pool growing up. My dad took care of it and the cardinal rule was that you avoided letting air suck into the pump at all...

I have a San Juan Catalina fiberglass pool, approximately 26X12. It is a kidney shaped pool. The 2 return jets are placed on the step (shallow) end of the pool. What is...

Suppose, hypothetically, you held the end of the pipe from the main drain higher than the level of water in your pool and opened the valve at the end. Would the water in...

Hello I'm new to this forum, and this is my first post.

My return valve broke so I had to buy a new one. I went to my local pool shop, to get one. They said it was a...

It looks like I have a small leak where the Sand Filter Body and the Multi-Port Valve meets. It appears it may only leak when the Filter is running, I do have to jiggle...

Recently replaced by lateral assembly valve in my Hayward sand filter. Now when I turn on my filter i have a small stream of water that constantly escapes thru my...

sun has bleached all the labels on valve,not a great memory. its a baquapure 26'' from rec warehouse that say 7 valve mutiport....any help would be appreciated?

I finally was able to start opening my pool yesterday. Hooked up everything but some o rings in the pump and filter fittings need to be replace before I can go any...

I was wondering if anyone could tell me why on startup my system is blowing a lot of air back into the pool and then what appears to be either millions of tiny bubbles...

It has been several years since we've opened our pool and we've run into a problem. There used to be the following pictures setup and working, but it seems the wires...

Started up pool for the season. No leaks, air etc. When I held my hand over the return jets the pressure or flow was low. Usually it will push your hand away strongly....

I have an american products pool pump. I am trying to remove the moter and impeller and the nut recessed in the housing is rusted and is rounded off. Do any of you have...

Hi
Im a new pool owner. I was learning the basics of the system when I noticed a leak at the top of my Waterways Crystal Clear DE canister at the bleed valve. While...

I just replaced my filter and pump. On first start up pressure reads 19 with good return flow and good suction on both skimmer and side wall suction lines. After a few...