my spa water is draining out of the spa and into the pool when pool shuts off. spa is above ground and waterfalls into pool. what can i do to fix. tried running spa and...

Have a less than a year old pool pump. The lid comes off fairly easy, but I have trouble replacing it. It's Really tight. Have to use a rubber mallet. Is their a trick...

Hi,
I apologize if this has been asked but I did a search and didn't find anything.
I'm trying to clean the impeller to a NPRA6E-147L inground pool Sta-Rite pump.
I've...

A tricky problem. I have checked out the website and forum but my problem seems wierd.
Pump and filter seem to work fine. Creepy krawly ticks away happily - suction is...

I noticed my spa leaking back into the pool (spa is higher than the pool). The leak would stop right below the returns so it cannot be the spa drain.

At first I...

I have an inground pool that is less than 10000 gallons with a small spa. The pump is a Pentair Whisperflow WF-28. Someone replaced the motor with a Champion 2HP 1.10...

Hi,
My system has been running at low pressure and flow lately. Less than 10 psi. I just cleaned the DE filter and not much change. Pump motor sounds ok I think? Any...

I have a ge pump for my inground swimming pool. When opening it up for the first time today, water started leaking from what looked like inside the motor. The pump was...

Has anyone ever purchased a Pentair Trition II tr60 with clear-pro technology sand filter. Part # 140212. Pentair claims that it will clean close to a de filter. I tried...

Guys/Gals , please help , i am going to crack...recently when i plug in my pool cleaner you can hear the pool pump take strain and the pressure drops from about 80 bar...

i have a 32X17 20k pool. to vacuum, the hose hooks up to the skimmer on top corner of he pool on the deep end, or there is a second suction point on he floor of pool...

I recently replaced my waterline tile, reset the coping, replastered and put in a new main drain cover, but the one last thing I need is somekind of valve for the...

Just bought a house with a gunite pool and there is no pressure at the filter. This is a simple set-up - no spa and only one valve. On the advice of the pool supply co.,...

I AM SETING UP A NEW ABOVED GROUND POOL CAN I HARD PUMB MY FILTER OR SOULD I US FLEX HOSE

Inground pool, de filter 2 skimmers, one skimmer plugged. With Main drain open no suction for Baracuda and skimmer basket, but primer stays full. when shut off main...

The pool's returns were working fine up until today, but now practically no water is returning into pool, while the filter's meter starts up at 40.

The pool has a...

I had to install the heat pump at high level (above garage, 3m above pool surface) due to noise considerations. Pump is 1.6 hp, filter 760 dia. Design total flow rate...

I have an inground vinyl pool. Recently I have noticed air bubbles in the return lines and the motor has become increasinly louder as if straining.

Hello,
I have a pump and filter. The filter is cylinder shape and housed in a large black plastic cylinder with rounded top and presure gauge installed on top. It has...

Hi, All, happy holiday.

I have two pump motors in my swimming pool. One for the swimming pool one for the hot tub.

Recently the motor for the swimming pool is dead....