About 4 Years ago we had the pool replastered. We discovered immediately that the attached spa had plaster in the bottom drain. The pool contractor came out and put a...

Just before I closed my pool, I noticed that the pressure had increased from 22 to 25 PSI. Normally the pool filter runs with a pressure between 22 and 23 PSI. I...

Happy Holidays to All,

I currently have a noisy pool motor, I replaced it about 8 years ago and its recently become noisy, I assume it is probably the bearings.
The...

Hello,

I recently had a leak detected underground associated with one of the jets in the spa and had it repaired immediately. Prior to the repair service, the jets in...

Just installed my new Epump and 5.0 upgrade.

It's working well and is very efficient.

Im trying to figure out why the basket never seems to fill with water........

My pool plumbing has 3 return valves/pipes: one goes to the waterfall, one to the lounge where it creates a bubbler-effect, and the third goes to the three pool wall...

Hello,
I have a Hayward S180T sand filter and noticed that sand was getting in the pool. I read some posts and decided to empty the filter of sand and water. I...

My caretaker 99 is malfunctioning! The system goes through 3 cycles that open caretakers at bottom of pool as normal, then the problem starts. The system then hangs for...

Hi, I have a 2.5 hp hayward pump and a 4 cartridge filter system for a 14,000 gallon in ground pool. I t is 6 years old now. The first 5 years were no problem, but this...

My water pump motor it is getting replace in the next 2 days, and I was thinking this might be a good time to get the pipes and valves replacec, even though it looks...

I have a Max-E-Glas II, one horsepower, model PRE6E-187L. the pool is kidney shaped, 34 feet long with a 9 foot deep-end. The pump turns on and immediately you see alot...

Hi,

Can anyone tell me why everytime i start my pump i have to prime it?

The problem i am having is that when i turn off my filter all of the water in the pump and...

After replacing my bearings and pump seal, I decided to make a waterproof pool pump cover to protect the pump against any inadvertent water infiltration due to the...

Hello .. I'd just like to tell you I', a new member. This is a great forum.

Recently I moved my entire pool plumbing and electrical to about 100ft away from the old...

I gave it a good 5 minute backwash and 2 minute rinse today and then took the head off to inspect the sand. It appears that there is some type of sediment in the sand...

Hi there,

I will try to describe my problem as best I can so that you may be able to help me out. Bought a house in June with a pool. Have been running it all summer,...

I have a Triton Purex FNS Plus, 36sq ft filter. I just replaced all the grids, because my previous ones were all broken. They're no more than 2 weeks old. I had DE on my...

I am new to pool maintenance and have been following all the instructions given to me by my landlord . My water is clear but I have recently got a purple dust/ sand on...

Several months ago I noticed the motor on our Hayward Super pump was running but no water was moving. We ordered a new pump, the exact same one. Turns out the impellar...

Hi I'm new. Anyway, we just got a Hayward navagator pool cleaner which we like so far. But today we decided that we just wanted the skimmers to operate for awhile since...