I recently purchased a home with a 28,000 gallon in-ground swimming pool. The previous (and cheap!) owner had replaced the old, bigger filter with a smaller filter (175...

The manifold, where the top air bleed fits, keeps breaking? I have a Pentair FNS Plus Vertical Grid DE filter 60 sq ft. a 1.5 horsepower pump, flow is 125 gal/min max...

We are having a 16x32 inground pool installed. 1hp motor - 1 1/2 inch pipe
Company has had many problems and redos - now they just tested the pump today and water flow...

Just opened my pool for the summer. inground 16x32 8 deep, salt water system, had to replace the pump motor, local pool guy said a 1hp motor was adequate for my pool....

When sweeping debris from the pool it somehow bypasses the brand new sta-rite 135TX filter and ejects the debris directly back in to the pool as if there were no filter...

Hello,

I just installed a new filter valve, replaced the sand and laterals, installed new gasket between valve and body. I was hoping I would finally have this thing...

We have been having this problem for about 2yrs. We have changed our sand in the filter, brushed down walls and bottom to center of pool and then vacum on waste. We then...

Most documentation I've read says to plumb the booster pump on the pool return side AFTER the pool/spa diverter valve and AFTER the heater. That is, in fact, how mine is...

I have 72SF DE filter which had a bad grid that I just replaced. Went thru 50 lbs of DE previously and now realize that most or all of that went into pool. With filter...

At the beginning of this swimming pool season I replaced my 15 year old Hayward 1 hp superpump because it wouldn't prime and create a vacuum. I replaced it with a new...

hello everyone, I am new to the forums. I didnt clean my pool for like 3 weeks and now when I go to clean it the water level is lower. So I let the water run until its...

Hi
I have an ingroundpool (14x28x5) with a 250sand filter and 1.5hp pump. Pipes are1.5 in
The backpressure when the valve is at recurcukate is at 23psi and when it is...

I have a DE filter system with a multiport valve. Every time I shut the filter off, when I start it up again clouds of DE come out of the return line into the pool for 3...

I have an inground pool with a d.e filter. The pool was very dirt after this winter. I vacuumed several times and backwashed with no problem. I needed to vacuum one more...

Hello, We have recently had to replace our topmount valve from a proline filter because the old one broke. The handle that changes the settings broke right off. We...

Was told motor bearings were bad. Have replaced motor but still have the same problem. This is a Hayward Cartridge filter and pump. Have run a garden hose at both ends...

Plannig to build an inground pool at our property.
and i wanna be the gen.contractor to save money. size would be 300 sq.meter.
5 ft. deep , hayward swimclear...

I'm using a standard sand filter & 2HP pump which I've had for a few years. Pressure normally runs at about 10-11lbs.

This year I encountered a problem which the...

I just went out to replace the sand in my Doughboy pool sand filter.The end of last year it wasn't filtering very well. Looks like a Silica I. The pool is a 24 ft round...

water drained out of the pool 1 foot below skimmers , I refilled the pool can I just turn the pump on to get the air out of the system