Hello, I live in South Florida, where it recently flooded and it seems my pool pump stopped working. I am looking to replace it but am a trying to do my research and...

Hey everyone.

Recently purchased a house that has a pool. First pool with a heater. I can’t figure out why there are two pipes going into one then into the heater....

Does anyone use an in-line cartridge filter when cleaning the fine (pollen etc) debris from their pool when vacuuming to waste using the pool pump and the suction from...

Hi.
I have an on going leak in my indoor concrete pool. Been performing a number of tests and believe this Valve needs replacing.

Can a hydrostatic Valve be replaced...

I have a ECO20110-2 sand filter and chlorinator on my above ground pool. Pump runs and filters just fine. I turned chlorinator on, got a low salt warning, added salt,...

I am currently installing a new 30x14 fiberglass inground pool with a remote 8' round tanning ledge. The ledge will be approx. 12" higher and have a spill-over into...

I have an in-ground pool and one of the nozzles is ejecting air bubbles.

The return line after the pump/filter runs to the pool, then it splits into two lines, one goes...

Ran into this in the fall when closing the pool. Trying to take the union off but it wont budge. Any suggestions before I cut it?

I have a series of Jandy valves on the suction side of the pump and one of them has a broken knob on the handle.

IMG_20230322_172323.jpg

I have already purchased a...

Hello, and thank you for allow me into this forum. My Name is Jose and I just bought this house with an unground pool and I just happened to found this pic piece in what...

Hello All,
I have hayward 1 hp power flo lx pump motor I am working on for my pool. I noticed that there had been rust on the shaft going between the motor and the...

To drain our pool, I use a sump pump with a 32mm flexible hose 30 metres long. However as its not a speedy pump, I leave it overnight to drain the pool. However, the...

Howdy!

I've got an inground pool from the 80's and while replacing some plumbing i came across something I can't identify.

Going through the pvc pool return line is...

Hi,

I have an Astral 320XT that I am trying to service as the pump has been noisy and I suspect it is a bearing. However I am not able to remove the impeller. I have...

Hi

This is how I found the interior of a PVC flex pipe connected to the bottom of a skimmer:

When it was new, it had a smooth interior surface, right?
In addition,...

I have a 2 HP Whisperflo on my small spa and believe it is over-sized. My spa only has 5 therapy jets. In therepy mode or just recirculation mode, it REALLY agitates the...

Classic issue for diagnosis: pool pump won't stay primed - immediately after pump turns off (auto or manual) I can see air bubbling up from the pump suction line into...

Hello,

I'm building a pool in Europe (230v).
I started looking into pumps and I realized that unlike what I initially thought, that all pool equipment must run on low...

I'm hoping someone may have some insight to help with an issue I've been working on all summer.

We recently moved into a home with a 20000 gallon in-ground pool. Ever...

Hi to you all,

Just joined the forum, so firstly... Hi!

I live in valencia, Spain and having recently bought a house with a pool I have inherited a pool pump system...