Pool Pumps, Filters, Plumbing & Piping

1051 topics

Page 45 of 53
- Jump to page:
Previous
1
…
43
44
45
46
47
…
53
Next

Topics

Replies

Views

Last post

Poolpum works - High Pressure Filter Gauge - NO FLOW!

by Martin M » Tue 19 Jun, 2007 22:06

First post

Out of the blue the pump stoppe pulling prime. I resealed all the couplings/fittings expecitng an air leak and still the same occurs.

I can see...

Last post

I don't know what that backflow preventer is, because I don't have anything like that in my pool. If you have high pressure building up in the...

1 Replies

880 Views

Last post by DanO
Tue 19 Jun, 2007 23:46
plumbing question

by j_goding » Mon 18 Jun, 2007 09:14

First post

I'm in the process of changing the pump and filter and am redoing the plumbing. The original system had a skimmer, a deep end water intake and a...

Last post

I'm in the process of changing the pump and filter and am redoing the plumbing. The original system had a skimmer, a deep end water intake and a...

1 Replies

1069 Views

Last post by Backglass
Mon 18 Jun, 2007 13:58
pump problem

by rayh78 » Sat 16 Jun, 2007 10:05

Have an 18 ft AG pool. Had a 1 hp Jacuzzi pump and filter and a lomart skimmer. Pump went bad so changed to a New Hayward power flo matrix 1 hp pump...

0 Replies

850 Views

Last post by rayh78
Sat 16 Jun, 2007 10:05
to quick disconnect or not?

by wiz28 » Fri 15 Jun, 2007 16:20

I just had all my lines replaced but when they re-plumbed the filter, pump,etc. they did not use a quick disconnect on any of it. I always had it...

0 Replies

779 Views

Last post by wiz28
Fri 15 Jun, 2007 16:20
Help! Bottom drain hose keeps collapsing

by hurst74 » Fri 08 Jun, 2007 23:30

First post

I have a 16x24 kayak pool and If I want to set the valve to bottom drain only it works for about 3 minutes then the hose starts collapsing and then...

Last post

I have a 16x24 kayak pool and If I want to set the valve to bottom drain only it works for about 3 minutes then the hose starts collapsing and then...

2 Replies

1466 Views

Last post by Backglass
Thu 14 Jun, 2007 12:53
leaking skimmer lines

by peter » Thu 31 May, 2007 12:09

First post

is there a way to seal existing skimmer lines(pvc) with out digging them out ? some kind of sealer you can pour in ? or sleave that will slow down...

Last post

Also, forget to mention I tried that stop leak myself and it did nothing for me. My leak was not that large either but the product did not work for...

3 Replies

1810 Views

Last post by wiz28
Wed 13 Jun, 2007 20:26
pool pump loses preasure

by joelynn » Mon 11 Jun, 2007 18:17

First post

I have a hayward pool pump above ground and it keeps losing preasure, it blows out a lot of water for about a half hour and then blows out very...

Last post

we have a powder filter, we dont know about the recirculate, were not sure how to do that. There are some air bubbles in the basket. Do you know how...

2 Replies

1279 Views

Last post by joelynn
Tue 12 Jun, 2007 05:49
LOSS OF SUCTION

by CONNIE1 » Thu 31 May, 2007 07:42

First post

I have DE Filter and hayward pump, above ground 18 X 33. I keep losing pressure, it surges then almost completely stops. Someone told me to take the...

Last post

get someone wityh bigger lips

2 Replies

1699 Views

Last post by steven
Mon 11 Jun, 2007 18:14
High filter pressure

by PopPop18 » Sat 09 Jun, 2007 19:45

First post

I have a problem with high filter pressure. I just opened my pool and the pressure went up to 20 psi after about 1 1/2 hours. I bumped it down and it...

Last post

How long since you opened the filter and cleaned the grids?

Maybe they're caked up with too much old DE, not all of the DE gets removed during...

1 Replies

1103 Views

Last post by howzball
Mon 11 Jun, 2007 15:55
DE filters

by Guest » Sat 09 Jun, 2007 11:13

First post

I cant seem to figure it out...I prime, checked for leaks, added more DE and still cant seem to get good water pressure in the filter or exiting....

Last post

To keep up the pressure, can you isolate any of the skimmers or drain with a valve?

In other words close down things like the drain while you're...

3 Replies

1233 Views

Last post by howzball
Mon 11 Jun, 2007 15:51
PLEASE HELP!!!

by Guest » Mon 11 Jun, 2007 09:15

First post

WE JUST INSTALLED OUR NEW FILTER (HAYWARD DE3600) WE DID THE PRE-COAT WITH THE D.E., AND VACUUMED WITH NO PROBLEM ON SATURDAY. I VACUUMED TO WASTE...

Last post

Sounds like a bad pressure gauge, not sure on the other issue, Good Luck

1 Replies

945 Views

Last post by Walter
Mon 11 Jun, 2007 13:30
Problem with suction at skimmer

by Brian87gt » Sat 09 Jun, 2007 12:53

I have a 1hp sand filter for my 21' above ground pool. I just refilled all of the pool water, and now there is hardly any suction at the skimmer, as...

0 Replies

868 Views

Last post by Brian87gt
Sat 09 Jun, 2007 12:53
I keep getting Hozed!

by mmm6075 » Thu 31 May, 2007 21:28

First post

My hoses do not want to stay attached to my pump. They will work fine for a while, but sometimes when I am vacuuming, the pressure I guess builds up...

Last post

I had an above ground pool in the past with the same problem. No matter what I tried, the hoses leaked or flew off at all the wrong times.

I...

2 Replies

1163 Views

Last post by Backglass
Fri 08 Jun, 2007 21:05
How many returns do I need?

by billboard_ne » Fri 08 Jun, 2007 20:41

I have an inground liner pool 16x32, no bottom drain, just the skimmer. Hayward 1hp motor, gas heater, and a sand filter. The pool currently has one...

0 Replies

1292 Views

Last post by billboard_ne
Fri 08 Jun, 2007 20:41
Pump Runs But Nothing Happening

by Guest » Tue 01 May, 2007 10:44

First post

I have a 30k gal pool, the motor seems to be running as smooth as always, yet nothing is happening, no water is getting pulled through the system....

Last post

If basket is full of water and it is still not pumping it has to be a broken impeller. I had the same thing happen last year, parts were easy to come...

7 Replies

2527 Views

Last post by billboard_ne
Fri 08 Jun, 2007 20:36
FILTER PROBLEM

by tomd572003 » Tue 05 Jun, 2007 12:14

First post

HERE IS MY PROBLEM WHEN I GET DONE WITH THE VAC AND BACK WASH THEN TURN THE VALVE BACK TO FILTER AND THEN TURN PUMP BACK ON I GET ALL OF MY DIRT BACK...

Last post

Does your filter have a rinse position, when done backwashing turn the pump off, switch the valve to rinse, turn pump back on. This will discharge...

2 Replies

1267 Views

Last post by billboard_ne
Fri 08 Jun, 2007 20:28
Problem with waste hose fitting

by Guest » Thu 07 Jun, 2007 19:50

Hi, all. My husband and I just successfully replaced our ancient DE filter with a Hayward 48 sq. ft. model, and we replaced the valve at the same...

0 Replies

691 Views

Last post by Guest
Thu 07 Jun, 2007 19:50
Hayward Pump and ReGenX RG700 PROBLEMS

by DanZ » Tue 06 Jun, 2006 20:56

First post

Hello, We bought our house in November and the lady who sold it to us told us that she hasn't done anything to the pool in two years. Mind you she...

Last post

I have found when initially opening a pool, if the algae level is high and extensive vacuuming is done to clean the pool, the algae will cake onto...

3 Replies

2941 Views

Last post by Bob
Thu 07 Jun, 2007 11:12
Sand, dirt, nastyness

by fox_forma » Tue 05 Jun, 2007 18:19

First post

Well I just started leasing a new place and it has an in ground pool. It looked great when we moved in then started getting dirty and green with...

Last post

Your pool guy is right, it is perfectly normal to get some very fine dusty particles accumulating in the bottom of your pool for some time after...

1 Replies

882 Views

Last post by DanO
Wed 06 Jun, 2007 22:46
vacuum not working

by dasl1509 » Tue 05 Jun, 2007 12:10

First post

Pool circulates with good pressure, 18 - 20 psi & have plenty of flow but when I plug my vacuum hose & navigator in there is very little...

Last post

Pool circulates with good pressure, 18 - 20 psi & have plenty of flow but when I plug my vacuum hose & navigator in there is very little...

1 Replies

1086 Views

Last post by Backglass
Tue 05 Jun, 2007 12:14

1051 topics

Page 45 of 53
- Jump to page:
Previous
1
…
43
44
45
46
47
…
53
Next

Return to Board Index

Who is online at the Pool Help Forum

Users browsing this forum: CommonCrawl [Bot] and 4 guests