I AM SETING UP A NEW ABOVED GROUND POOL CAN I HARD PUMB MY FILTER OR SOULD I US FLEX HOSE

Inground pool, de filter 2 skimmers, one skimmer plugged. With Main drain open no suction for Baracuda and skimmer basket, but primer stays full. when shut off main...

The pool's returns were working fine up until today, but now practically no water is returning into pool, while the filter's meter starts up at 40.

The pool has a...

I had to install the heat pump at high level (above garage, 3m above pool surface) due to noise considerations. Pump is 1.6 hp, filter 760 dia. Design total flow rate...

I have an inground vinyl pool. Recently I have noticed air bubbles in the return lines and the motor has become increasinly louder as if straining.

Hello,
I have a pump and filter. The filter is cylinder shape and housed in a large black plastic cylinder with rounded top and presure gauge installed on top. It has...

Hi, All, happy holiday.

I have two pump motors in my swimming pool. One for the swimming pool one for the hot tub.

Recently the motor for the swimming pool is dead....

About 4 Years ago we had the pool replastered. We discovered immediately that the attached spa had plaster in the bottom drain. The pool contractor came out and put a...

Just before I closed my pool, I noticed that the pressure had increased from 22 to 25 PSI. Normally the pool filter runs with a pressure between 22 and 23 PSI. I...

Happy Holidays to All,

I currently have a noisy pool motor, I replaced it about 8 years ago and its recently become noisy, I assume it is probably the bearings.
The...

Hello,

I recently had a leak detected underground associated with one of the jets in the spa and had it repaired immediately. Prior to the repair service, the jets in...

Just installed my new Epump and 5.0 upgrade.

It's working well and is very efficient.

Im trying to figure out why the basket never seems to fill with water........

My pool plumbing has 3 return valves/pipes: one goes to the waterfall, one to the lounge where it creates a bubbler-effect, and the third goes to the three pool wall...

Hello,
I have a Hayward S180T sand filter and noticed that sand was getting in the pool. I read some posts and decided to empty the filter of sand and water. I...

My caretaker 99 is malfunctioning! The system goes through 3 cycles that open caretakers at bottom of pool as normal, then the problem starts. The system then hangs for...

Hi, I have a 2.5 hp hayward pump and a 4 cartridge filter system for a 14,000 gallon in ground pool. I t is 6 years old now. The first 5 years were no problem, but this...

My water pump motor it is getting replace in the next 2 days, and I was thinking this might be a good time to get the pipes and valves replacec, even though it looks...

I have a Max-E-Glas II, one horsepower, model PRE6E-187L. the pool is kidney shaped, 34 feet long with a 9 foot deep-end. The pump turns on and immediately you see alot...

Hi,

Can anyone tell me why everytime i start my pump i have to prime it?

The problem i am having is that when i turn off my filter all of the water in the pump and...

After replacing my bearings and pump seal, I decided to make a waterproof pool pump cover to protect the pump against any inadvertent water infiltration due to the...