Pool Pumps, Filters, Plumbing & Piping

1039 topics

Page 48 of 52
- Jump to page:
Previous
1
…
46
47
48
49
50
…
52
Next

Topics

Replies

Views

Last post

high pressure. possible return line blockage

by cOS » Sat 03 Mar, 2007 22:31

First post

hello. I have a high pressure problem with the filter system. I have tried replacing the sand and backwashing without any success in reducing the...

Last post

Try filling the pool up more and see if that fixes the issue.

8 Replies

3406 Views

Last post by dynamictiger
Mon 26 Mar, 2007 04:30
converting above ground pool plumbing to pvc

by dboyce » Sun 15 Oct, 2006 07:07

First post

It has seemed over the last couple of years that the length of time that the flexible plastic pipe that we have always used has been failing. We are...

Last post

Zeobrit dot com is the link this stuff is relly worth looking in to and it is about 25$ US for 25 LBS and you will need 75 per 150lbs of sand and...

5 Replies

10239 Views

Last post by Ricksp65
Wed 21 Mar, 2007 09:36
Pump will not maintain prime on pool side

by chuckj » Sun 18 Mar, 2007 19:55

First post

I have an in-ground, gunite pool with attached spa. A few weeks ago a freak occurance caused the spa to drain and the pump to run without water for...

Last post

The seals in the pump may be okay. It is most likely a seal or o ring on the pool suction side

3 Replies

1416 Views

Last post by dynamictiger
Tue 20 Mar, 2007 15:03
pump and filter replacement

by amj » Mon 19 Mar, 2007 17:15

I need to replace my pump and filter not sure what size I need. My pool has a hot also together its 23000 gallons. I also need to replace the booster...

0 Replies

736 Views

Last post by amj
Mon 19 Mar, 2007 17:15
Baqua Pure Filter Low Pressure

by pebbles3630 » Sat 17 Mar, 2007 19:13

First post

Hello all, I am kind of new to the pool thing. I moved into a house last Sept. and the pool was already establised and running fine. We winterized...

Last post

Those readings maybe correct for your system. It is a little difficult to be sure.

If everything seems to be running okay and you are not having...

1 Replies

1571 Views

Last post by dynamictiger
Sun 18 Mar, 2007 15:08
Attached pool spa-one jet not working

by rsehres » Wed 14 Mar, 2007 20:09

Just noted one jet in the spa not working, any thoughts?, all other working fine, pool 2 years old, in ground, pump working, intake valve clear--any...

0 Replies

984 Views

Last post by rsehres
Wed 14 Mar, 2007 20:09
pump drain line

by mrhobb » Sun 04 Mar, 2007 12:50

First post

Hello! I have a 35 yr old vinyl lined in ground pool. I don't know anything about the age of the pump. The waste line stays full and drains when I...

Last post

The short answer is yes most likely the valve can be rebuilt and yes they do need rebuilding from time to time. The long answer is maybe as the age...

1 Replies

927 Views

Last post by dynamictiger
Sun 04 Mar, 2007 14:56
Main drain connection

by menniearg » Sat 27 Jan, 2007 17:50

First post

Just had the pump and filter plumbed in and I have realised that the main drain has not been connected to the pump. Every plumbing diagram I see...

Last post

Thanks for the reply.

I'm 100% certain that the main drain has not been connected to the pump or skimmer so I guess that means I will have to...

2 Replies

2417 Views

Last post by Guest
Fri 02 Feb, 2007 10:17
Spider gasket / glue removal

by miker1755 » Wed 06 Dec, 2006 10:20

First post

I am trying to replace the spider gasket in my multi-port valve. It was apparently put together with excessive glue and the old gasket comes apart...

Last post

I need to do the same job. If glue is not to be used, what holds the gasket in place? Thanks.

2 Replies

3692 Views

Last post by Phil Vitek
Tue 23 Jan, 2007 20:43
New pool and pump questions

by browe » Tue 09 Jan, 2007 19:43

First post

I have a new pool and am having some problems. My Polaris 380 doesn't climb the walls or really work the way it is supposed to like it does when I...

Last post

I have not sold many polaris 380. However, I understood they ran on a totally seperate booster pump and your filter pressure is not related or...

2 Replies

1517 Views

Last post by browe
Wed 10 Jan, 2007 20:37
air bubbles

by signal26 » Thu 14 Dec, 2006 20:21

First post

I have a new pool and lately I have noticed some air comming up through the feeder pipe on the front of the filler basket when the pump is off....

Last post

this also works well if your pump has any elevation above the water level.

4 Replies

2158 Views

Last post by poolmedic signal 31
Tue 09 Jan, 2007 20:03
Low PSI from Hayward II Superpump

by [email protected] » Thu 24 Aug, 2006 16:29

First post

My pump sounds a little different and the PSI is down to 8. It usually runs at 12 PSI. Everything is clear. No idea whats wrong.

Last post

Pump sounds different normally implies cavitation. This is a sound like rocks tumbling around inside the pump.

This is typically caused by air...

3 Replies

1735 Views

Last post by dynamictiger
Thu 28 Dec, 2006 15:24
equipment layout

by prpickett » Sat 19 Aug, 2006 10:32

First post

I have questions regarding layout of an in-line chlorinator, ozonator, booster pump for cleaner, and gas heater. Each item gives typical installation...

Last post

Sounds pretty good to me. A couple of things, though:

1.) make sure check valve is between heater and chlorinator/ozone generator.

2.) why both...

1 Replies

2920 Views

Last post by poolnerd
Thu 28 Dec, 2006 00:42
air in lines

by silverwings » Fri 17 Nov, 2006 13:36

First post

My pool has water bubbles coming out of the output pipes in the pool.Also the pressure on the guage will go up to where it is supposed to be and stay...

Last post

I agree with the previous post. If same problem after replacing o-rings and so on, try replacing seal and re-plumbing pump inlet; if pump has run dry...

4 Replies

2204 Views

Last post by poolnerd
Thu 28 Dec, 2006 00:22
Filter replace advice for community pool

by pjones2127 » Sun 27 Aug, 2006 22:00

First post

Hello everyone. I'm new to this forum and like most people, I'm here looking for some sound advice. I'm board president of the Camelot Recreation...

Last post

Sorry for the late reply, I have only just joined this forum.

For commercial pools the rules are slightly different than domestic pools. The...

1 Replies

1056 Views

Last post by dynamictiger
Sat 09 Dec, 2006 18:04
Best way to unblock intake pipe?

by Miki » Fri 24 Nov, 2006 18:56

First post

I believe my vacuum may have sucked up 1-2 rocks that my nephew has dropped into the pool. My husband and I have taken apart the hose to check if...

Last post

This is more indicative of air not being purged completely from your filter on start up. I am assuming your filter pump is the vacuum pump and it is...

1 Replies

2002 Views

Last post by dynamictiger
Fri 24 Nov, 2006 19:17
Jacuzzi Pump

by ptim » Sat 18 Nov, 2006 19:40

I've been having problems with my neighbors trees dropping leaves in my pool. My Jacuzzi pump wasnt priming, so I took the back part of my pump off...

0 Replies

1125 Views

Last post by ptim
Sat 18 Nov, 2006 19:40
Air in the system
1

2
by Alex » Sun 15 Oct, 2006 08:52

First post

Hi,

By accident, during the cleaning, my Jacuzzi was left without the water with the running pump. Now, the system is full with the air, and I...

Last post

Thank you very much for your time; it is almost a week after the "accident"-everything seems to be OK....thanks again
12 Replies

4436 Views

Last post by Alex
Thu 19 Oct, 2006 19:51
Multi-port Valve

by etm1109 » Sat 07 Oct, 2006 01:54

My multi-port valve is shot. I found a replacement at a pool supply company. The sales rep told me to buy a rubber gasket. Along with all of this he...

0 Replies

1118 Views

Last post by etm1109
Sat 07 Oct, 2006 01:54
above ground vs in ground pumps

by Knoxville Guy » Thu 05 Oct, 2006 10:26

First post

I have an in ground pool and need to replace my Hayward pump. I have an opportunity to buy another brand slightly used pump at a very reasonable...

Last post

Above-ground pools usually have the pump well below water level and therefore the ability for the pump to be self-priming is not usually a problem....

1 Replies

950 Views

Last post by Demons1964
Thu 05 Oct, 2006 18:35

1039 topics

Page 48 of 52
- Jump to page:
Previous
1
…
46
47
48
49
50
…
52
Next

Return to Board Index

Who is online at the Pool Help Forum

Users browsing this forum: CommonCrawl [Bot] and 5 guests