I bought a new pool pump, but the wiring instructions did not come in the package. I have a 110 volt home electrical. The pool motor can be wired for 110 or 220...

Hi
have an issue with my pump which only popped up today. Went to vacuum floc waste to waste, but the mpv sent 50% to waste, 50% back to pool, thus making it messy. It...

My house lost power very briefly but for some reason it caused my pool pump to shut off (low voltage code). I flipped the breaker and that fixed the pool pump issue...

I have one of these - The transparent round twist on cover is broken (see right side of photo at the link) I wrote to Excel Pool Products about getting just the lid. No...

my 380 seems to run nicely except for it will float many times. Once I saw the bag full of air which seemed to help it to float. But without the airy bag, it will float...

Hi everyone,

I have a bad control board on my Rheem pool heater. The connector for the temperature sensor (green arrow) came off the board. The solder points are very...

Hi all. I am attempting to install microlite where a globrite died.
I added the adapter thinking I was good to go.
Not so sure..
There is a vinyl raised faceplate around...

Hi folks, we have truly stumped our pool tech. Our cartridge filter fills with air when connecting the pool cleaner through one of the two holes in the bottom of the...

I only recently realized that the pump that powers the robot for my pool consumes more power than the main pump (which is also single speed).

My robot is functional...

Thoughts on How to fix this?
an ice storm and long frozen spell we went thru. froze the top of the water and the weight of the ice pulled the return line down and thru...

If anyone else out there is using the Pentair Intellichem, here is a spot we can lament together on our decision to purchase it. Not saying its bad, but, for something...

​Just got a new liner installed and had the pool company replace the step gasket, face plates, beauty strips etc. First let me say I have ZERO confidence in this pool...

Today I was installing a Jandy Truclear system and need to connect the ground lug on the bottom of the panel to the equipment or ground it. Instructions say to bond it...

The tiles in my swimming pool are broken and I would like to change new one, what kind of glue is the best to stick the tiles that is not harmless to the body, is there...

I need to replace the tubing fittings but when I unscrew it water gushes out. Is there a way to stop it or do I just have to let it empty on it's own? Thank you.

Hi, Everyone-

We have an older pool panel controller, an Aqualink RS6. We would like to change this over to something more modern that has a smartphone app that we can...

I took out my grids to clean them thouroughly and inspect (very closely) them for any tears that might cause them to fail. Happily they looked in great condition however...

I am in the process of resurfacing my pool. I picked out a pool light but it won't be in until after the pool is resurface and filled. Do you have to have a light...

Good Afternoon,

Can anyone help. - I have an Endless Pools unit that has a technical issue.

For those that know - the unit itself is fairly straight forward. It has a...