Greetings - I am in the midst of rebooting the pool after a year of no use due to plumbing leaks. Leaks are repaired and I am faced with a pond coloured pool. Have been...

I'm in the process of having my pool built and the equipment and lighting doesn't include any basic automation. Using the LED light as an example, it will be wired to a...

My intex pump pulls water out of the pool just fine, but is not pumping water back into the pool. The sand is two years old. I just backwashed. Sometimes it will pump...

I just purchased a replacement salt cell and noticed that one of the plates is slightly bent and in contact with the adjacent plate. Only the corner of the plate is in...

my pump is not priming properly. I noticed it started when the union was leaking. so i replace the union and it is tight and sealed at this point. I took the pump apart...

Hello!

I am hoping you guys can provide some guidance on a repair I have to make to my father-in-law's pool. He has an American Products (Pentair) vertical DE filter...

I have a Pentair 1.5 HP pump. Every morning I have to go out and press the number 1 to get the pump going. I initially thought it was losing prime, but when I press the...

Earlier this year I had to replace a part of the motor that runs the pump for my pool.

After replacing the conductor, I reconnected everything with no leaks and all...

I am having a problem where when i move my multiport valve from backwash to filter, i am still getting water coming out of the backwash/rinse return. Its not as much...

Have replaced pump motor - old one was due for replacement - bearings shot.
New motor is same HP and RPM and voltage rating as old one.
Replaced shaft seal and gaskets...

I need to replace my old Savi Melody Cartridge Lights which are discontinued.
This product line from Jandy seems like a good replacement option, however, it has several...

I have a six month old old Polaris F4TR. It is my second one. Great machine except for reliability. Polaris replaced the first one under warranty due to wearing out...

I am looking forward to ordering the first cover for our pool. It's taken quite a bit of research, but I have finally found a DIY way to measure, order, and install the...

Hello all,

I'm continuing a multi-week effort to rescue our neglected pool water. I was making good progress, with the number of visible steps going from 1, to 2, to 3,...

Hello All,

Year 2 of restoring this badly neglected house. And now for the next thing with the pool - the equipment shed (power/controller/pumping/filtering).

Like...

Big problem!! I ordered a Avenli 10ft x30in swimming pool assuming it would come with a pump and filter. There's ONLY a drain plug.
I have a pump from another pool I...

Hi all.

I have a Hayward pool heater (model #H250FDN). Over the past week, the heater fired up and heated just fine. All display functions seemed to operating normally...

Hello folks,

First time poster,

Having a hard time with my pump staying primed. Pumps are located above pool, have two jandy valves one for spa and one for pool....

Hi all.

I have a Hayward pool heater (model #H250FDN). Over the past week, the heater fired up and heated just fine. All display functions seemed to operating normally...