hello,
I noticed I had some leaks at the front of the pvc piece going into the basket and the line going to the filter. This was causing air to show up in the basket....

Hello. New member here. Wasn't sure where to introduce myself so doing it here.

I live in the Dallas Texas area. I have an inground 'normal' gunite/plaster pool. The...

I bought a house with a pool (about 10 years old). It has a Nature 2 Professional G mineral sanitizing system. Of course, there was no manuals left behind... I'm...

Ive been trying to get this pool clear of sediment however every time I vacuum the bottom about 2 mins into vacuuming it starts blowing back into the pool. Any...

Hello! Since switching to a salt chlorination system, I've had to replace my Polaris cleaner's hose multiple times. Is there a known issue with the salt system degrading...

Newbie here! I'm in Ottawa, ON, I just purchased a home, the pool is a vinyl 16x32 without heat. I'm going to add a heater, but I'm getting mixed messages. I have three...

Need a new pump for North East season. Thinking about either a dual speed or variable speed pump. Look for reliability and saving on the electric bill. I have a IG pool,...

:cry:

So my husband always handled the pool. He passed away last June and immediately when I went to get it fixed to there were issues. I was able to fix them with the...

Pool cleaner doesn't seem to clean as it should. In fact, since installation in 2012, it has never cleaned very well. Kreepy Krauly Platinum. Had it checked recently and...

So I'm here looking for some help. I've been battling with my heater for over 2 seasons and figured it's time to ask for some help.

Sta Rite heater, with a 42001-0096...

Hi guys,

ALL of a sudden, my perfectly working Barracuda g3 now insists on floating c. 8 to 12 inches above the bottom of the pool, titled at an angle. It does climb...

Timer (Intermatic) for booster pump was acting erratic so replaced it. Then observed that booster timer was only running (keeping time) when main pump was running, i.e....

Trying to track down a unicorn! Called a bunch of the pool stores in Tucson and no results. Looking for 10 umbrella sleeve caps \ plugs. Found a bunch that are 1.5"...

My first post to this site, at the end of last season my pump was drawing in air to the extent that the heat pump was under performing, and the filter a large 36"...

HI,

I recently purchased a home with an inground pool. I was told that it might need some work but I can get by for a year or two. Long story short, I now need to redo...

Hello. My Polaris pump recently went out (the threads corroded off the shaft and the impeller would not turn). I have an extra main pool pump (see attached picture). I'm...

Hi folks,

First time poster here... A question for you folks - can you please recommend a decent robotic pool vac. Preferably a few hundred is what I want to spend,...

I have a two speed, 2 HP Hayward Pump 230 Volt. I'm trying to rewire but it doesn't seem to work. My problem is that
the wires coming from the panel are 2 blacks, 1 red...

I have had my hammerhead pool Vacuum for 3 years I don't hear alot of people talking about these. My company uses this daily although You can still use it for...

New to the forum...Is anyone familiar with this?
I removed the PCB# 8124A
Assembly# 8125G
(That board is fried)

I replaced it with
PCB# 8124A
Assembly #8125 from ebay...