Pool cleaner doesn't seem to clean as it should. In fact, since installation in 2012, it has never cleaned very well. Kreepy Krauly Platinum. Had it checked recently and...

So I'm here looking for some help. I've been battling with my heater for over 2 seasons and figured it's time to ask for some help.

Sta Rite heater, with a 42001-0096...

Hi guys,

ALL of a sudden, my perfectly working Barracuda g3 now insists on floating c. 8 to 12 inches above the bottom of the pool, titled at an angle. It does climb...

Timer (Intermatic) for booster pump was acting erratic so replaced it. Then observed that booster timer was only running (keeping time) when main pump was running, i.e....

Trying to track down a unicorn! Called a bunch of the pool stores in Tucson and no results. Looking for 10 umbrella sleeve caps \ plugs. Found a bunch that are 1.5"...

My first post to this site, at the end of last season my pump was drawing in air to the extent that the heat pump was under performing, and the filter a large 36"...

HI,

I recently purchased a home with an inground pool. I was told that it might need some work but I can get by for a year or two. Long story short, I now need to redo...

Hello. My Polaris pump recently went out (the threads corroded off the shaft and the impeller would not turn). I have an extra main pool pump (see attached picture). I'm...

Hi folks,

First time poster here... A question for you folks - can you please recommend a decent robotic pool vac. Preferably a few hundred is what I want to spend,...

I have a two speed, 2 HP Hayward Pump 230 Volt. I'm trying to rewire but it doesn't seem to work. My problem is that
the wires coming from the panel are 2 blacks, 1 red...

I have had my hammerhead pool Vacuum for 3 years I don't hear alot of people talking about these. My company uses this daily although You can still use it for...

New to the forum...Is anyone familiar with this?
I removed the PCB# 8124A
Assembly# 8125G
(That board is fried)

I replaced it with
PCB# 8124A
Assembly #8125 from ebay...

Hi all,
Looking for advice, suggestions, help on pool cleaners.
We are located in Australia.
My hubby is keen on a kreepy krawly but am wondering if there were better...

My mother just had a new impermeable safety cover installed. There is a bit of coping showing (maybe a couple inches or so) at a couple of spots where the pool isn't a...

Being new pool guy I was enjoying my pool when i noticed that not all the little round water pop up cleaning jets were not working properly.
I of course went to youtube...

hi - just purchased a home that came with all the Hayward gear installed/setup.

Trying to unlock the Configuration Menu to check my settings. The installation menu...

Hi
I have a problem with a pipe running between sand filter and heater ( approx 450mm) has collapsed ( sucked almost flat). It happened last year too, I thought then it...

Hello to All,

I currently have a bad leak in the side of my pool filter on the bottom part. My filter is a Pentair CCP420 cartridge filter. I have priced out buying...

Hello new here. First post.
Air bubbles in pool. Not in filter basket though. Replaced n lubed all orings. No visible leaks. All chemicals, dirt, and de back in pool...

Hello everyone. This is my first post to the forum. I have an above ground pool with two drains at the surface of the pool. There is a valve on the outside of the pool...