will the Intermatic actuator fit a Compool valve?

thanks

Sent from my SM-G981U using Tapatalk

Just got my new pool installed this year. Learning little by little.

Does anyone know if they make caps for the holes where the hand rail goes? So, if I decide not to...

I’m new to owning a pool matter of fact it’s being built now, the question I have is they installed my pump,filter and equipment on a fiberglass pad but nothing is...

Hi, I have an old inground pool built with the house in the 60s. The suction line from the skimmer to the pump has been replaced with 2" PVC. The return lines are...

i just had a new pentair mastertemp 250 heater installed replacing an old mastertemp 250. i was able to control temp from iphone/ipad using the screenlogic app for many...

I have a handy aqualink system. It has 3 laminar deck jets a pool light, spa, heater and chlorinator. Out of the blue on a roughly three year old system the pool light...

I need to buy a test kit so that I dont have to go to the pool store to test my water.

Need all the basics plus Phosphates, CYA and metals

What do you reccommend?

My tank drains back into the pool when the pump is turned off. This creates a situation where the pump has to strain and sometime does an auto shutoff because it can't...

Greetings - I am in the midst of rebooting the pool after a year of no use due to plumbing leaks. Leaks are repaired and I am faced with a pond coloured pool. Have been...

I'm in the process of having my pool built and the equipment and lighting doesn't include any basic automation. Using the LED light as an example, it will be wired to a...

My intex pump pulls water out of the pool just fine, but is not pumping water back into the pool. The sand is two years old. I just backwashed. Sometimes it will pump...

I just purchased a replacement salt cell and noticed that one of the plates is slightly bent and in contact with the adjacent plate. Only the corner of the plate is in...

my pump is not priming properly. I noticed it started when the union was leaking. so i replace the union and it is tight and sealed at this point. I took the pump apart...

Hello!

I am hoping you guys can provide some guidance on a repair I have to make to my father-in-law's pool. He has an American Products (Pentair) vertical DE filter...

I have a Pentair 1.5 HP pump. Every morning I have to go out and press the number 1 to get the pump going. I initially thought it was losing prime, but when I press the...

Earlier this year I had to replace a part of the motor that runs the pump for my pool.

After replacing the conductor, I reconnected everything with no leaks and all...

I am having a problem where when i move my multiport valve from backwash to filter, i am still getting water coming out of the backwash/rinse return. Its not as much...

Have replaced pump motor - old one was due for replacement - bearings shot.
New motor is same HP and RPM and voltage rating as old one.
Replaced shaft seal and gaskets...

I need to replace my old Savi Melody Cartridge Lights which are discontinued.
This product line from Jandy seems like a good replacement option, however, it has several...