Hello. I have a 12'x52" round above ground pool. I am looking at a heater. Will a 14000 btu/hr Titanium Heat exchanger be sufficient to keep the pool warm? Thank you

Hello,
I have an old slide made by Aquaslide, from Brownsville Texas and I am looking for parts (leg supports, tubing, etc.). Apparently the company is no longer in...

I came back from a trip and my pump wasn't running as it should have been. I noticed the relief valve on my filter had broken off. After fixing the relief valve I have...

So my main pump is down and I wanted to run my waterfall and now that pump won't move any water. It had a drippy leak in a pipe connection that now seems worse; would...

What uses is a pool help forum if you can't get a post approved in a whole day? Asking for a friend.

Hi all. I am now the owner of a pool ! I need to clean the salt cell. It is impossible to unscrew. How do I tell which direction to twist each one ? Do I turn the top...

I have been having trouble recently with poor suction and the filter tank is not pressurizing.

Symptoms:
1-low suction. Not enough to drive pool cleaner (I have a...

Hi! I'm new the the forum and a relative newbie to pools (this is our 3rd year).

We have a 14' round above ground that we converted to saltwater w/ an Intex ECO7111...

My name is Rick Caylor from MO. I have a 1 piece San Juan Fiberglass 35,000 gallon pool.

It was installed in 2004 and they installed the PG2000 Pentair Fiber Optic...

Hi There!
We recently moved to a new home (new to us), and it was built in the 90's.
It has a pool, and I cannot find where the hydro-plug/hydrostatic valve is.
The pool...

I was doing a visual inspection of my above-ground pool and I noticed an upright was starting to lean. Not outward, but side to side about 1/8". It prompted me to...

I have been having some problems with my system that I cannot seem to solve. It started with a low suction rate at the skimmer basket. I thought I had a blockage so I...

My raypak 336 digital heater, was having issue with high limit switch 1, (unitherm governor is relatively new also is the bypass spring) when I checked the switch was...

Hi All,

My SWG started showing less salt, so I added more salt and it turns out I ended up putting in too much salt. So I removed water a foot at a time, until I got...

Hey, I'm hoping you kind souls can help me out with an issue I've been trying to tackle for a while now - opening the pool.

My setup is an 18ft diameter by 4ft deep...

Hello,
I'm new to this site and was hoping someone can tell me where to get the J5 connector on GLX-PCB-RITE Board.
Any help would be appreciated. Thank You :)

We've had our pool built about 4 years ago and have always just paid the same installing pool company to replace the LED lights. I have Google searched and YouTube...

Hello, Looking for help. I'm rebuilding this control board and trying to find the J5 connector and hoping someone can help.
Thank You :D

Noticed that my pool pump was off. turn off and turned back on (manual) it started to make noise and shut off. can you please advise the pump needs to be replaced or can...