Hi, I have a new home + pool with old equipment. Several things are broken according to three different pool companies. I've read some articles that talk about sticking...

So when I got this pool, the air blower for the spa was pretty anemic and VERY loud. it would take several minutes for any air to reach the spa, and then it was only a...

Hi everyone, my first post here, but have been a pool owner for 10 years and feel comfortably with chemicals and maintenance, however have a plumbing question. Pool is a...

I have an Hayward-Perflex EC-65 DE pump/filter for my 25K inground. My problem is one of the 2 drainplugs at the bottom of the pump will not stay in. It shoots out the...

Good morning,
We have a pool with a rock fountain that hasn't been connected since we bought the house. We recently started working to try to get it going, and connected...

Hi i have recently bought an aeroator, the only problem is I cant connect it to my Hayward outlet which is a 1.5" male fitting and the aerator device has a...

Anyone know where to get just the bottom piece of the diving board. I have a 6 foot board.

Sent from my SM-G960U using Tapatalk

Opened the pool, cleaned it, then tried to start the heater. Faulted out, found the troubleshooting guide, fan was bad. Got a fan from an authorized dealer, replaced...

I have a 9 year old Hayward H250 Pool heater. I have the BD code due to a F4 fuse that keeps blowing. I changed the blower thinking that was the issue. F4 blew again so...

We have taken on a pool with a Pool Pilot system that was partly dismantled. The Salt Chlorine Generator (75003) has a dead LCD display, so I have bypassed that control...

I wrote this all out and created the post and it went to the ether somewhere, so here’s try #2

Lots of dead algae when i opened the pool this year. Vacuumed to waste...

Hi! Never really had an algae problem before, little green tint but caught it and SLAMed it. Opened it a few weeks ago and had a massive amount of dead algae in it....

Hello I bought a PoolDevil Pro automatic surface cleaner that hooks to the output flow on the pool. My issue is that I cannot connect it because there are not threads on...

I have a hayward aqua rite system. Salt level is 3200 as it was tested. I have installed 2 different t-15 cells. Both new and both read 5000 ppm. I have replaced the...

I need to recalibrate my pH machine.
It is plugged in to the same electrical circuit of my pump, so there are both either on or off.

To do the calibration, I need the...

My ladder is deeply rusted on about 5 cm at about the waterline. The rest is in fine condition.

It seems a bit of a shame to replace the whole ladder. Is there a way to...

I need help deciding between these 2 pool covers, for my bubble cover of 5m by 8 metres.

1)

- 180 euros
- 12 kg
- 2 wheels on each side

2)

- 220 euros
- 10.5 kg...

Hi all,

I have sand in my pool. I bought the house 2 years ago and was planning on replacing the sand soon. I'm guessing the standpipe or laterals are broken allowing...

I went from a 1 hp pump to a 1.5 hp pump because I moved the pump/filter further away (about 50') from the pool. I keep seeing water come out of the Waste port when the...

Bought a house two years ago with a nice inground pool and I'm still stumbling along trying to figure things out.

Setup is salt chlorination, but last year I noticed...