I've been using a pressurized Polaris pool cleaner for a decade. It finally gave up the ghost and will need substantial maintenance and replacement parts to get back...

I suspect my filter needs to be cleaned; I'm waiting for some warmer weather, but I wanted to get some ideas as to my filter pressure.

I have a vacuum line and a...

Hello, first of all I’m a newbie but I do have people that can help me.

I bought a 2nd salt cell (compupool 3 salt cell grc/j40-3) becaise I was told you can’t them...

so I had a 220V 2 speed Century Pump connected to a Pantair 2 speed relay. I'm in the process of replacing the motor but sadly, I didn't make notes of which wire goes...

Located in SW Florida a new home to me but not a new heater . Noticed the Freon lines from the evaporator coil to I believe is the expansion valve lines developed frost...

Hello everyone. First time posting here. I have a pump out on my pool water falls... it is a Pentair Challenger 2 HP 115/230V Up Rated Single Speed Pool Pump (also have...

I have a Pentair 250 minimax heater connected to a cam pool upgrade panel. The heater starts runs and heats up as it should but after running for about 15 to 20 minutes...

Noticed my breaker had tripped so I reset it, and within a few seconds it tripped again. When I opened up the wiring compartment on the pump, it was charred and you...

I replaced the Polaris motor however Polaris 360 not moving.

It's about a 20 year old pool. I changed out all the screen filters. Polaris rebuilt last year and was...

Hi all. I'm deaf, so I don't know much about radios or music in general. My parents built their swimming pool and installed a mains powered cd stereo with wall speakers....

We have a 1000 gallon above ground pool. Getting ready to drain the pool for winter.
We used the normal pool pump to drain about half the water. Now the water level is...

Hello,

I have the following heater: Raypak Digital Natural Gas Pool Heater 266k BTU | Electronic Ignition | P-R266A-EN-C 009217 P-M266A-EN-C 009963. Unfortunately the...

I would like to be able to program more functions. Currently, I can assign programmed times to the filter pump on and off, aux cleaner pump on and off, and the waterfall...

Hi All

I have 3 underwater lights permanently mounted at equal distances along the length of my 12 meter long pool. The problem is these are recessed lights and have a...

When I unscrewed the pool gauge the stem broke off in the socket. I have seen others ask this question and tried the eaze off solution. The largest bit was just a tiny...

In a few days I hope to add some pictures. Sorry I don’t have any good ones right now.

I replaced the spring with membrane in the piece that screws into the wall. It...

Hello,
I have owned an inground pool (6 years) that uses floor pop-ups to clean the pool. I did a Caretaker rebuild kit about 4 years ago when it first stopped cycling,...

I have an underwater pool light that stopped working. The symptoms are:
it turned on briefly but then went out
attempts to turn it on and off fail
when I turn it on,...

We have an old in-ground pool with a vinyl liner. There are eye hooks that protrude out from the sides between the border of the shallow end to place a float line which...

Hi,
We installed a Hayward Perflex DE filter last month. From the time we installed it the return blew out a cloud of white powder for the first 8-10 seconds after...