Hi folks,

First time poster here... A question for you folks - can you please recommend a decent robotic pool vac. Preferably a few hundred is what I want to spend,...

I have a two speed, 2 HP Hayward Pump 230 Volt. I'm trying to rewire but it doesn't seem to work. My problem is that
the wires coming from the panel are 2 blacks, 1 red...

I have had my hammerhead pool Vacuum for 3 years I don't hear alot of people talking about these. My company uses this daily although You can still use it for...

New to the forum...Is anyone familiar with this?
I removed the PCB# 8124A
Assembly# 8125G
(That board is fried)

I replaced it with
PCB# 8124A
Assembly #8125 from ebay...

Hi all,
Looking for advice, suggestions, help on pool cleaners.
We are located in Australia.
My hubby is keen on a kreepy krawly but am wondering if there were better...

My mother just had a new impermeable safety cover installed. There is a bit of coping showing (maybe a couple inches or so) at a couple of spots where the pool isn't a...

Being new pool guy I was enjoying my pool when i noticed that not all the little round water pop up cleaning jets were not working properly.
I of course went to youtube...

hi - just purchased a home that came with all the Hayward gear installed/setup.

Trying to unlock the Configuration Menu to check my settings. The installation menu...

Hi
I have a problem with a pipe running between sand filter and heater ( approx 450mm) has collapsed ( sucked almost flat). It happened last year too, I thought then it...

Hello to All,

I currently have a bad leak in the side of my pool filter on the bottom part. My filter is a Pentair CCP420 cartridge filter. I have priced out buying...

Hello new here. First post.
Air bubbles in pool. Not in filter basket though. Replaced n lubed all orings. No visible leaks. All chemicals, dirt, and de back in pool...

Hello everyone. This is my first post to the forum. I have an above ground pool with two drains at the surface of the pool. There is a valve on the outside of the pool...

I have a problem with my Barracuda. It moves, it pulses, it sucks. But, it no longer covers the entire bottom of the pool. Why? HELP!

So i have hayward xstream filter about 5 or so years old. Last few weeks ive had this loud noise coming from the filter unit not motor. Ive had the pressure gauge break...

Hi,

Our Barracuda seems to be addited to the pool steps and can't seem to do its job in any other parts of the pool. Help! We've cleaned the filters 2 x now as...

The options for Robotic Pool Cleaners is very over whelming. I'm in the market for a budget (~$700) robotic cleaner. As of right now I have narrowed my choices to 3...

Anyone out there with experience using ELAN HW-EB-102 Pool and Spa Serial Edge Brick to talk to Pentair ACU-TROL AK110. I am assembling my pool automation system (of...

Hi Guys.
I've had my small 6000 gallon 'fun' pool up and running for about 6 months now. The HUGE thing that is a major problem is dragging out all the hoses and...

Hi All,

I am new to this forum. My wife and I just bought a house with a pool.
I'm a new pool owner and I'm not familiar with all of these valves and their functions....

I was hoping I could get some guidance from the members. We own a summer cabin that has a prehistoric pool from the early 60s. The pool is solidly built (pure concrete...