Please help. We have a reasonably new baracuda to automatically clean the bottom of the pool and it keeps stopping 2-5 mins after it starts. Not sure what could be a...

Tell me more about these electric and hydro pool covers?

The circulation water is good on a daily basis. Once I begin to vacuum, the pressure goes from 10 to 3 and the vacuum hardly pulls the water from the pool. When I pull...

Trying to find the triangle tool key, that removes the top rails on an above ground Vouge pool.
stan831@bellsouth.net

I have acquired an old fiberglass pool slide and am starting work on restoring it. The slide looks like it might be an SR Smith Rogue Grand Rapids slide (deck only, no...

HI all im new to the pool scene.
IM deciding to get a robotic cleaner for my fibre glass pool.
Its a 60,000 litre pool 12 mtrs by 4 mtrs.

Dolphin seems to cop allot of...

I am almost sure that that is what is forming the foam in the pool. (please e-mail me if you think I am wrong)

a bit of water is running down the filter around the...

i have seen on these forums where acid washing a vinyl liner is not really covered, what are some of your takes on this, i have drained and used muretic acid on mine and...

have a Salt Water In-Ground pool with a Cubby Pool Pilot. Almost a month ago, it quit working. No lights at the control panel and no salt output. I thought it was the...

Help!

I have a 2006 model Hayward Viper cleaner that will not stop taking right turns. The cleaner will run anywhere from 5-15 seconds then complete the better part of...

We've got a Jandy Aqualink RS Wireless (not PDA, but older wireless) controller that came with the house when we bought it 2 yrs ago. A few months back the controller...

We have a Hayward Navigator that we inherited when we bought our house. I noticed that it stopped moving properly. When I pulled the Nav or the bottom of the pool the...

I just bought a house with a fiberglass pool. I know nothing about pools and have no experience with them. This is what I can tell you about our pool...it has 2 jets...

For weeks I haven't had a chlorine reading.. I figured it may be that my cell is too old (6yrs) and needs replacing... So bought a new Zodiac replacement cell LT-15 for...

My skimmers have slowly stopped working over the past few years. Looking into the skimmer and down the main drain line, it looks like the walls of the flexible PVC pipe...

Hi there,

Pulled out my Barracuda last weekend which was working fine but just wanted to add some extra hose lengths. A few lengths broke so I left the whole Barra out...

:x Ok Long Story.......pool was grren.....changed sand in filter....chlorine and shock and now i am clear except for the debris on the bottom. My kontikki will start...

Help - in ground pool - gurgling in suction line / pump will not completely fill / producing continuous air bubbles in return lines - what is the problem / solution ??

Beware not all 12 mil covers are the same thickness or quality!!

I recently purchased my third 12 mil solar cover. The previous two both lasted 5-6 years. Both my...

Hi Everyone,
I have a salt cell that must be routinely cleaned. It has an "O" ring on each end. Due to the tight tolerances, it is difficult to remove and many...