I have an old fiber stars 6001 light single light the fiber optic is shot and doesnt transfer light well, want to replace with below.
Does anyone have any cheaper...

Hi all,
l am looking for advice on replacing both of the skimmers of my in ground concrete and tiled pool.
One has become detached from pipe below and was loosing a lot...

Looking for a part number for PAC-FAB model 60-X31X Housing 62-XXXX. So far no luck.

Hello
I have an American Products R-400 BCL inground pool light. It needs a new gasket, but I cannot find a cross reference for this model number anywhere. Pentair...

Good Morning; i need help. My skimmer is not working i need some guidence.
1) Skimmer does not have "O" Rubber Ring inside
2)the skimmer doesn't have the...

I'll preface this by saying that IMO, the pool in question should be completely torn down and replaced; it was not properly winterized, the cover was not used, and the...

What kind of wire should be used in a pool? I wonder if this was the wrong kind. Seems dangerous.

We have a pool with a liner that is in our home, inside. We have a badu jet super sport swim against that is bringing sand into our pool and we believe it’s also the...

I am a newbie with this new pool in my recently closed home. I have noticed that my water pump is only pulling from this skimmer. I do not believe it is pulling from the...

Hi all,

I moved into my new house 5 months ago and am now finding the problems I've got with the pool.
Both of the pool lights, 1 in the pool and 1 in the spa, don't...

I have a lot of rust developing around my skimmer:

p3.jpeg
p5.jpeg

I removed the inside white plaque and saw the screws' heads were rusty.

I will replace the...

Hi folks,

Love the forum :)

I have a Hayward OmniHub automation system and everything (minus my lights) is connected and controllable from it. The PB wired a remote...

Hi All,

We have a time sensitive need to close our automatic pool cover which is currently stuck open. The pool cover will continue opening, but will not close and we...

I was trying to manually vacuum my pool. As I was putting in a skimmer plug, it dropped out of my grip and was sucked down the line,there was still suction even though I...

Hi! The reason why I am trying to identify this skimmer is because currently, water is only being sucked from the skimmer. This is a very old pool and it came with the...

I need to reduce the back pressure in my spa and want to replace my 4 existing jets (Hayward SP1434B) with something that has more flow. I've searched the internet and...

Can somebody please help me figure out what skimmer housing I have because nobody seams to know? I bought a rainbow vacmate because my pool is from the 70s and doesn’t...

hi I am new here can anyone tell me what type of light this is and how to get it out
I just perched the home 2weeks back and I'm stumped

Hello. I have an inground fiberglass pool. I am planning to install an underwater light, since all the battery or solar powered light do not last. I got a Pentair...

Currently a Pentair 120V light is installed and it's not working - water in the light housing got wet and it's all rusted.

The light is connected with a 60 ft cord that...