I want to put a hand rail in the pool from the top step to the bottom of the pool . What type of bolts should i use that don't rust and mark the...

After reading some of the posts on this forum, I think the laterals in my sand filter are broken . Problem is, I have never done this before . The...

My Hayward in ground pool light has burned out. I have the housing out of the pool and the bulb separated from the front plate. Can I just replace...

TIPS TO CONNECT LINE SWIVEL KIT TO JANDY RAYVAC HOSE. PLEASE HELP ME

1 off my Pool skimmers has stopped sucking the other is fine. Any ideas please.

Hi all, I have been getting my 3+ year neglected pool I bought on foreclosure up and running. I needed light parts for a Hayward SP 541 starlight...

Hi guys, i have a 12ft Bestway above ground Vinyl pool as per link below.
My question is has anyone ever attached Return eyeballs to an above ground...

Only when the vacuum is ON, it continue to prime. When I switch to FULL skimmer on the valve port there is no prime and everything works like it...

I have a salt water system and came home to find that the spa was half drained and the pool has the normal amount of water in it. I tried turning the...

I have a Media Master model 0-1701-013. Over the winter the valve and assembly has cracked. is there anywhere you can order just the valve and...

I made a bad rookie mistake and attached my pool vacuum in my underground pool to the bottom of the Skimmer without the basket and now it's auctioned...

1.We have a Pentair FNS plus filter system that has been using diatomaceous earth for years..We replaced the diatomaceous earth with Fiber Clear and...

We bought an older home 2 yrs. ago. The inground pool was re-surfaced 3 yrs. ago. The contractor didn't put the eyeballs back in the returns. I've...

Hi all, I'm hoping someone out there can send me in the right direction.

Just had my in-ground pool drained, acid washed, and refilled. The original...

There is a leak on the outside wall dribbling down from the skimmer. Can I use plumber's paste to fix it? Or should I replace the gaskets?

I would like to know how I can fix small holes in my pools sides. When I am under the decking I see holes and I see the liner on the other side of...

I presently have the water depth about 1/2 inch below the very top of the skimmer opening. The skimmer does not work very well even if I route all...

I am replacing an Amerlite pool light and the "special" screw that must be placed at 12:00 is too short to reach the hole in the niche. Is...

I bought a used Aqualeader agp 30" The skimmer plate on the inside of the pool was broken in two places. I for the life of me,cannot find the...

I have a new 24' above ground pool. When the pump turns on it doesn't always prime. I believe this is because the flapper/weir sticks in the closed...