TIPS TO CONNECT LINE SWIVEL KIT TO JANDY RAYVAC HOSE. PLEASE HELP ME

1 off my Pool skimmers has stopped sucking the other is fine. Any ideas please.

Hi all, I have been getting my 3+ year neglected pool I bought on foreclosure up and running. I needed light parts for a Hayward SP 541 starlight that was a 300 watt 12v...

Hi guys, i have a 12ft Bestway above ground Vinyl pool as per link below.
My question is has anyone ever attached Return eyeballs to an above ground pool, and if so how...

Only when the vacuum is ON, it continue to prime. When I switch to FULL skimmer on the valve port there is no prime and everything works like it should.. Now i do get...

I have a salt water system and came home to find that the spa was half drained and the pool has the normal amount of water in it. I tried turning the pool on again and...

I have a Media Master model 0-1701-013. Over the winter the valve and assembly has cracked. is there anywhere you can order just the valve and assembly. the tank is good...

I made a bad rookie mistake and attached my pool vacuum in my underground pool to the bottom of the Skimmer without the basket and now it's auctioned there even with the...

1.We have a Pentair FNS plus filter system that has been using diatomaceous earth for years..We replaced the diatomaceous earth with Fiber Clear and all of a sudden the...

We bought an older home 2 yrs. ago. The inground pool was re-surfaced 3 yrs. ago. The contractor didn't put the eyeballs back in the returns. I've tried to find...

Hi all, I'm hoping someone out there can send me in the right direction.

Just had my in-ground pool drained, acid washed, and refilled. The original pool light was...

There is a leak on the outside wall dribbling down from the skimmer. Can I use plumber's paste to fix it? Or should I replace the gaskets?

I would like to know how I can fix small holes in my pools sides. When I am under the decking I see holes and I see the liner on the other side of the holes. Should I...

I presently have the water depth about 1/2 inch below the very top of the skimmer opening. The skimmer does not work very well even if I route all water return through...

I am replacing an Amerlite pool light and the "special" screw that must be placed at 12:00 is too short to reach the hole in the niche. Is there a way to fix...

I bought a used Aqualeader agp 30" The skimmer plate on the inside of the pool was broken in two places. I for the life of me,cannot find the same bolt pattern...

I have a new 24' above ground pool. When the pump turns on it doesn't always prime. I believe this is because the flapper/weir sticks in the closed position. Does anyone...

20+ year old gunite pool with approx 11 inch niche for light. Contractor replaced light, charging $400+, but said it was hard to find right size light. The new light...

We just bought our first house and it came with a 24' ft above ground pool that was left unmaintained for at least 3 years. I'm in the process of getting it back in...

I have an older model Swimquip skimmer that is cracked and in need of replacement. It was installed in the early 70's and the part number I got off it is 8650, which...