Dear forum guests,

i would like to appreciate your advice and professional help.

We are planning to build the perimeter deck -level overflow pool with overflow...

Hi everyone, fab here. This is my first post in this forum.
We've been looking into getting a pool. My wife was more inclined to go for the half-in/half out pools. I am...

I'm looking to install a fiberglass pool in my backyard. My sons are doing competitive swimming and as they grow up, I want to make sure the pool will accommodate their...

Little bit of a back story here to help clear up questions that might come up.

I started digging a pond with my excavator. I was looking into ways to maintain the water...

Hello,

I was hoping to get some advise on the next steps I need to take for an inground pool we’re demoing. So far, we have several holes punched in the bottom and...

I'm tearing out the old concrete deck around the pool and installing stone pavers. The old coping that the concrete deck was pour to shifted with the concrete and no...

Good morning everyone,

Another beautiful summer day beginning here in Silver Spring MD.

I had written in this sub-forum over a year ago about our pool liner having...

If my understanding is correct, a painted (Chlorinated Rubber) pool gets its waterproofing from the paint, not the underlying substrate.

In that case, hypothetically...

I just reinstall my 21 ft Aqua Leader pool with a new drain. While I finish preparing and smoothing the ground with sand before putting the liner, I notice that the...

So, we have a 19 year old vinyl liner inground pool. We just had the liner replaced two years ago. Concrete decking around pool with white metal coping.

We were going...

Hey! So we recently installed a semi inground pool. We had all walls level and supported. We then had concrete poured on all four corners (it’s a 15x30 steel wall) and...

My pool was originally built in 1978 with a marcite finish--which I know contained asbestos at the time.

When we purchased the house in 2018, the pool was showing...

Hi,

I hope I can get some opinions here. We are having a new pool installed, the gunite was done about 5-6 wks ago, it rained for the first time about 3 weeks after...

I live in Ontario, Canada. I am currently having a pool installed. The pool company laid grout, and the original liner was the wrong size. It took two weeks for the...

Currently refurbishing our inground concrete pool. I’m having it tiled and ground all the chlorinated paint off.
I’m going to tank it all first but the floor has been...

I am replacing my liner. (Esther Williams in ground). I noticed the bead track pulling out / loosened a few spots (it pulls out from the groove between the concrete...

I am replacing my in ground liner, and would like to “patch” / smooth the divots in the floor with the recommended Portland cement / vermiculite mix. How “thin” can this...

Pool planned to start construction in mid-July.

Below are some details:
-24x44 rectangle pool (3ft shallow/8ft deep
-Hayward Tristar VS 1.85hp pump
-Hayward S244T SAND...

Hi Guys new member here. We are a family of 5 (mom dad and 3 girls ages 10/8/6) and currently have a 16x32 rectangle pool. At the end of the summer we are moving across...

Good morning, first time pool owner here. Purchased 18' round Riviera steel wall pool. While I would have loved to have an installer come, finding an above-ground pool...